Quantitative firing transformations of a triaxial ceramic by X-ray diffraction methods
Open Access
- 1 December 2014
- journal article
- Published by FapUNIFESP (SciELO) in Cerâmica
- Vol. 60 (356) , 524-531
Abstract
The firing transformations of traditional (clay based) ceramics are of technological and archeological interest, and are usually reported qualitatively or semiquantitatively. These kinds of systems present an important complexity, especially for X-ray diffraction techniques, due to the presence of fully crystalline, low crystalline and amorphous phases. In this article we present the results of a qualitative and quantitative X-ray diffraction Rietveld analysis of the fully crystalline (kaolinite, quartz, cristobalite, feldspars and/or mullite), the low crystalline (metakaolinite and/or spinel type pre-mullite) and glassy phases evolution of a triaxial (clay-quartz-feldspar) ceramic fired in a wide temperature range between 900 and 1300 ºC. The employed methodology to determine low crystalline and glassy phase abundances is based in a combination of the internal standard method and the use of a nanocrystalline model where the long-range order is lost, respectively. A preliminary sintering characterization was carried out by contraction, density and porosity evolution with the firing temperature. Simultaneous thermo-gravimetric and differential thermal analysis was carried out to elucidate the actual temperature at which the chemical changes occur. Finally, the quantitative analysis based on the Rietveld refinement of the X-ray diffraction patterns was performed. The kaolinite decomposition into metakaolinite was determined quantitatively; the intermediate (980 ºC) spinel type alumino-silicate formation was also quantified; the incongruent fusion of the potash feldspar was observed and quantified together with the final mullitization and the amorphous (glassy) phase formation.The methodology used to analyze the X-ray diffraction patterns proved to be suitable to evaluate quantitatively the thermal transformations that occur in a complex system like the triaxial ceramics. The evaluated phases can be easily correlated with the processing variables and materials properties. These correlations can be employed for materials characterization, design and processing control.Keywords
This publication has 34 references indexed in Scilit:
- Clays and bodies for ceramic tiles: Reappraisal and technological classificationApplied Clay Science, 2014
- Firing transformations of an argentinean calcareous commercial clayCerâmica, 2013
- Influence of Firing Conditions on Properties of Red CeramicMaterials Science Forum, 2012
- Characterization of non-calcareous "thin" red clay from south-eastern Brazil: applicability in wall tile manufactureCerâmica, 2012
- Influence of composition on mechanical behaviour of porcelain tile. Part III: Effect of the cooling rate of the firing cycleMaterials Science and Engineering: A, 2011
- Mineralogy and firing transformations of Permo–Triassic clays used in the manufacturing of ceramic tile bodiesApplied Clay Science, 2009
- The influence of heating rate on the thermal behaviour and mullite formation from a kaolin raw materialCeramics International, 2001
- Microstructural Evolution in Triaxial PorcelainJournal of the American Ceramic Society, 2000
- Firing transformations of cretaceous clays used in the manufacturing of ceramic tilesApplied Clay Science, 1999
- Porcelain—Raw Materials, Processing, Phase Evolution, and Mechanical BehaviorJournal of the American Ceramic Society, 1998