Evidence and Characterization of Crystallographic Defect and Material Quality after SLIM-Cut Process
Authors:
- 29 June 2011
- journal article
- Published by Springer Nature in MRS Proceedings
- Vol. 1323
Abstract
The SLIM-Cut process is a kerf-free wafering technique to obtain silicon substrates as thin as 50μm. The quality of the resulting material must be assessed to ensure that this innovative Si-foil approach does not jeopardize the potential efficiency of the final solar cell in terms of electronic activity, defect density and location. For that reason, we performed Microwave-Detected Photoconductance Decay (MW-PCD), Deep-Level Transient Spectroscopy (DLTS) and optical inspections after defect etching of the foils surface. Analyses indicate that SLIM-Cut generates crystallographic defects which create deep level traps that have a negative impact on the lifetime of the silicon foil. Nonetheless, a decrease of the thermal budget will lead to a reduction of plasticity and hence lower the amount of defects and increase the foil quality.Keywords
This publication has 6 references indexed in Scilit:
- Stress-induced large-area lift-off of crystalline Si filmsApplied Physics A, 2007
- Structural and electrical properties of metal impurities at dislocations in siliconPhysica Status Solidi (a), 2005
- Fracture anisotropy in silicon single crystalMaterials Science and Engineering: A, 1999
- Temperature-Dependent Onset of Yielding in Dislocation-Free Silicon: Evidence of a Brittle-To-Ductile TransitionMRS Proceedings, 1998
- Accurate method for the determination of bulk minority-carrier lifetimes of mono- and multicrystalline silicon wafersJournal of Applied Physics, 1997
- The brittle–ductile transition in silicon. I. ExperimentsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1989