Numerical simulation for welding pool and welding arc with variable active element and welding parameters
Authors:
- 1 August 2009
- journal article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 14 (6) , 509-516
Abstract
A numerical modelling of the welding arc and weld pool is established for moving argon shielded gas tungsten arc welding to systematically investigate the effect of the active element oxygen and the welding parameters on the Marangoni convection and the weld shape using FLUENT software. The different welding parameters will change the temperature distribution and gradient on the pool surface, and affect the strength of Marangoni convection and the weld shape. Under high oxygen content, the weld depth/width (D/W) ratio substantially depends on the welding parameters. A high welding speed or large electrode gap (arc length) will make the weld D/W ratio decrease. The weld D/W ratio initially increases and then remains constant around 0·5 with the increasing welding current. When the oxygen content is lower, the weld D/W ratio decreases with the increasing welding current. However, the weld D/W ratio is not sensitive to the welding speed or electrode gap. The predicted weld D/W ratio agrees well with the experimental results.Keywords
This publication has 21 references indexed in Scilit:
- Numerical study and comparisons of gas tungsten arc properties between argon and nitrogenComputational Materials Science, 2009
- Numerical modelling of an electric arc and its interaction with the anode: part II. The three-dimensional model—influence of external forces on the arc columnJournal of Physics D: Applied Physics, 2005
- Influence of Welding Parameters and Shielding Gas Composition on GTA Weld ShapeISIJ International, 2005
- Heat transfer and fluid flow during laser spot welding of 304 stainless steelJournal of Physics D: Applied Physics, 2003
- Weld Penetration and Marangoni Convection with Oxide Fluxes in GTA WeldingMATERIALS TRANSACTIONS, 2002
- Heat transfer and fluid flow in a partially or fully penetrated weld pool in gas tungsten arc weldingInternational Journal of Heat and Mass Transfer, 2001
- Modeling of the effects of surface-active elements on flow patterns and weld penetrationMetallurgical and Materials Transactions B, 2001
- Modeling macro-and microstructures of Gas-Metal-Arc Welded HSLA-100 steelMetallurgical and Materials Transactions B, 1999
- Surface tension of binary metal—surface active solute systems under conditions relevant to welding metallurgyMetallurgical Transactions B, 1988
- An enthalpy method for convection/diffusion phase changeInternational Journal for Numerical Methods in Engineering, 1987