Effects of strike point location on upstream electron density in HL-3 by SOLPS-ITER modeling
- 1 November 2026
- journal article
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (11) , 115016
Abstract
Experiments in L-mode on the HL-3 tokamak show that, under similar discharge conditions, the divertor strike point (SP) location significantly affects upstream edge and divertor plasma parameters. When the SP is located at the corner rather than the bottom, the upstream electron density (at the outer midplane n e,OMP ) is substantially higher. In this work, simulations were conducted using the edge plasma code SOLPS-ITER with the experimental parameters, which well reproduce the experimentally observed trends and provide insight into the mechanisms by which the SP location influences n e,OMP . The results show that when the SP is located at the corner, D atoms reflected from the right baffle accumulate in the downstream divertor region, enhancing the flux of D atoms entering the core region near the X -point. The subsequent ionization of these D atoms produces a stronger particle source in the core region and contributes to the higher core plasma density in the SPC case. Moreover, the simulations indicate that the difference in n e,sep between the SPC and SPB cases increases with input power. Besides stronger core ionization enhancing core plasma density in the SPC case, two additional effects contribute: (1) the peak D + flux incident on the corner divertor target ( ϕ D + ,OT peak ) sputters more C impurities, which are then transported upstream, resulting in a higher upstream carbon density n C,OMP and consequently increasing n e,OMP ; (2) in the SPC case, the D + poloidal flux through the outer divertor entrance to the downstream region is reduced, further increasing the difference in n e,OMP .Keywords
Funding Information
- Liaoning Province Science and Technology Project (2024JH2/102600021)
- China Postdoctoral Science Foundation (2024M750305)
- National Natural Science Foundation of China under Grant (12405252)
- Natural Science Foundation of Sichuan Province (2026NSFSC0005)
- Fundamental Research Funds for the Central Universities (No. DUTZD25210)
- Dalian Science & Technology Talents (No. 2022RJ11)
- National MCF Energy R&D Program of China (2022YFE03180300)
This publication has 45 references indexed in Scilit:
- The first application of flush probe arrays on HL-3 tokamakNuclear Materials and Energy, 2025
- Edge-localized mode mitigation enabled by active control of pedestal density gradient with new EAST tokamak divertorPhysics of Plasmas, 2025
- Design of the Collective Thomson Scattering System on HL-3 tokamakEPJ Web of Conferences, 2024
- Simulations of Ar seeding by SOLPS-ITER for a slot-type divertor conceptPhysics of Plasmas, 2020
- Exploring SF- in-out asymmetry and detachment bifurcation in HL-2M with E × B by SOLPSNuclear Materials and Energy, 2020
- Effects of carbon impurities on the power radiation and tungsten target erosion in EASTPhysics of Plasmas, 2018
- Advanced divertor concept design and analysis for HL-2MFusion Engineering and Design, 2016
- The component development status of HL-2M tokamakFusion Engineering and Design, 2015
- Design study of JT-60SA divertor for high heat and particle controllabilityFusion Engineering and Design, 2008
- Plasma Edge Physics with B2‐EireneContributions to Plasma Physics, 2006