Distance-dependent plasma composition and ion energy in high power impulse magnetron sputtering
Open Access
- 23 June 2010
- journal article
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 43 (27) , 275204
Abstract
The plasma composition of high power impulse magnetron sputtering (HIPIMS) has been studied for titanium and chromium targets using a combined energy analyser and quadrupole mass spectrometer. Measurements were done at distances from 50 to 300 mm from the sputtering target. Ti and Cr are similar in atomic mass but have significantly different sputter yields, which gives interesting clues on the effect of the target on plasma generation and transport of atoms. The Ti and Cr HIPIMS plasmas operated at a peak target current density of ∼0.5 A cm−2. The measurements of the argon and metal ion content as well as the ion energy distribution functions showed that (1) singly and doubly charged ions were found for argon as well as for the target metal, (2) the majority of ions were singly charged argon for both metals at all distances investigated, (3) the Cr ion density was maintained to distances further from the target than Ti. Gas rarefaction was identified as a main factor promoting transport of metal ions, with the stronger effect observed for Cr, the material with higher sputter yield. Cr ions were found to displace a significant portion of the gas ions, whereas this was less evident in the Ti case. The observations indicate that the presence of metal vapour promotes charge exchange and reduces the electron temperature and thereby practically prevents the production of Ar2+ ions near the target. The content of higher charge states of metal ions depends on the probability of charge exchange with argon.Keywords
This publication has 22 references indexed in Scilit:
- Novel TiAlCN/VCN nanoscale multilayer PVD coatings deposited by the combined high-power impulse magnetron sputtering/unbalanced magnetron sputtering (HIPIMS/UBM) technologyVacuum, 2008
- Cathodic Arcs2008
- High power impulse magnetron sputtering: Current-voltage-time characteristics indicate the onset of sustained self-sputteringJournal of Applied Physics, 2007
- Deposition of zinc oxide layers by high-power impulse magnetron sputteringJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2007
- Phase tailoring of Ta thin films by highly ionized pulsed magnetron sputteringThin Solid Films, 2007
- CrAlYN/CrN superlattice coatings deposited by the combined high power impulse magnetron sputtering/unbalanced magnetron sputtering techniqueSurface and Coatings Technology, 2006
- Ionized physical vapor deposition (IPVD): A review of technology and applicationsThin Solid Films, 2006
- Investigation of high power impulse magnetron sputtering pretreated interfaces for adhesion enhancement of hard coatings on steelSurface and Coatings Technology, 2006
- A comprehensive model of stress generation and relief processes in thin films deposited with energetic ionsSurface and Coatings Technology, 2006
- Comparison of microstructure and mechanical properties of chromium nitride-based coatings deposited by high power impulse magnetron sputtering and by the combined steered cathodic arc/unbalanced magnetron techniqueThin Solid Films, 2004