Scalable bonding of nanofibrous polytetrafluoroethylene (PTFE) membranes on microstructures
Authors:
- Mehdi MortazaviMMMehdi Mortazavi
- Abdolreza FazeliAFAbdolreza Fazeli
- Saeed MoghaddamSMSaeed Moghaddam
- 1 December 2017
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 28 (1) , 015001
Abstract
Expanded polytetrafluoroethylene (ePTFE) nanofibrous membranes exhibit high porosity (80%–90%), high gas permeability, chemical inertness, and superhydrophobicity, which makes them a suitable choice in many demanding fields including industrial filtration, medical implants, bio-/nano- sensors/actuators and microanalysis (i.e. lab-on-a-chip). However, one of the major challenges that inhibit implementation of such membranes is their inability to bond to other materials due to their intrinsic low surface energy and chemical inertness. Prior attempts to improve adhesion of ePTFE membranes to other surfaces involved surface chemical treatments which have not been successful due to degradation of the mechanical integrity and the breakthrough pressure of the membrane. Here, we report a simple and scalable method of bonding ePTFE membranes to different surfaces via the introduction of an intermediate adhesive layer. While a variety of adhesives can be used with this technique, the highest bonding performance is obtained for adhesives that have moderate contact angles with the substrate and low contact angles with the membrane. A thin layer of an adhesive can be uniformly applied onto micro-patterned substrates with feature sizes down to 5 µ m using a roll-coating process. Membrane-based microchannel and micropillar devices with burst pressures of up to 200 kPa have been successfully fabricated and tested. A thin layer of the membrane remains attached to the substrate after debonding, suggesting that mechanical interlocking through nanofiber engagement is the main mechanism of adhesion.Keywords
Funding Information
- U.S. Department of Energy (DE-AR0000133)
This publication has 30 references indexed in Scilit:
- Microscale layering of liquid and vapor phases within microstructures for a new generation two-phase heat sinkInternational Journal of Heat and Mass Transfer, 2016
- Impact of micromixing on performance of a membrane-based absorberEnergy, 2015
- Hierarchical biphilic micro/nanostructures for a new generation phase-change heat sinkApplied Thermal Engineering, 2015
- Microscale phase separator for selective extraction of CO2 from methanol solution flowJournal of Power Sources, 2014
- Moving beyond the limits of mass transport in liquid absorbent microfilms through the implementation of surface-induced vorticesEnergy, 2014
- Nanofibrous membrane-based absorption refrigeration systemInternational Journal of Refrigeration, 2013
- Absorption characteristics of lithium bromide (LiBr) solution constrained by superhydrophobic nanofibrous structuresInternational Journal of Heat and Mass Transfer, 2013
- Hydraulic and thermal characteristics of a vapor venting two-phase microchannel heat exchangerInternational Journal of Heat and Mass Transfer, 2011
- Electrochemical gas sensor using a novel gas permeable electrode modified by ion implantationSurface and Coatings Technology, 2007
- Dehumidification of air by a hygroscopic liquid membrane supported on surface of a hydrophobic microporous membraneJournal of Membrane Science, 2000