High-yield W-band monolithic HEMT low-noise amplifier and image rejection downconverter chips
Authors:
- K.W. ChangKCK.W. Chang
- T.N. TonTTT.N. Ton
- M. BiedenbenderMBM. Biedenbender
- S.T. ChenSCS.T. Chen
- G.S. DowGDG.S. Dow
- K.L. TanKTK.L. Tan
- B.R. AllenBAB.R. Allen
- 1 August 1993
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Guided Wave Letters
- Vol. 3 (8) , 281-283
Abstract
High-yield W-band monolithic microwave integrated circuits (MMICs), namely, a three-stage low-noise amplifier (LNA) and a monolithic image rejection downconverter (IRD), are discussed. The LNA is used as the front end followed by an image rejection mixer (IRM). These MMICs were fabricated in the 0.1- mu m AlGaAs-InGaAs-GaAs HEMT production line. The LNA demonstrated a typical 17-dB gain and 4.5-5.5-dB noise figure at 94 GHz. The complete monolithic IRD has a measured conversion gain of 7-9 dB with a single-side-band noise figure of 6 dB when downconverting a 93-95-GHz RF signal to 50-500 MHz. The downconversion requires an LO power of 9 dBm. The development of these MMICs shows the increasing maturity of GaAs-based HEMT MMIC technology at W-band.<>Keywords
This publication has 5 references indexed in Scilit:
- An Automated W-Band On-Wafer Noise Figure Measurement System1993
- High-performance in W-band monolithic pseudomorphic InGaAs HEMT LNA's and design/analysis methodologyIEEE Transactions on Microwave Theory and Techniques, 1992
- A W-band image-rejection downconverterIEEE Transactions on Microwave Theory and Techniques, 1992
- A W-band monolithic downconverterIEEE Transactions on Microwave Theory and Techniques, 1991
- W-band monolithic oscillator using InAlAs/InGaAs HEMTElectronics Letters, 1990