On array models theoretical predictions versus measurements for the growth of cells and dendrites in the transient solidification of binary alloys
- 8 February 2011
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 91 (12) , 1705-1723
Abstract
Most of the theoretical studies of the growth of cells/dendrites in the literature are based on the assumption that it is a steady-state phenomenon. The analysis of cells/dendritic structures in the unsteady-state regime is very important, since it encompasses the majority of industrial solidification processes. The aim of the present investigation was to validate the predictions furnished by the cellular and primary dendritic growth models in the literature for unsteady-state conditions against a large spectrum of experimental data, which includes those for a variety of Al alloys (Al–Cu, Al–Si, Al–Fe, Al–Bi, Al–Ni, Al–Sn) and low thermal diffusivity alloys, such as Sn–Pb and Pb–Sb. The predictions furnished by the Hunt–Lu model do not match the cellular experimental scatter for any examined alloy system. However, this model matches well with the primary dendritic growth of Al alloys, with the exception of Al–Sn alloys, for which the Hunt–Thomas approach has to be applied. The primary dendritic predictions of Bouchard–Kirkaldy's model, performed with the originally suggested a 1 calibration factors are, in most cases, located above the experimental points. Experimental growth laws relating cellular and dendritic spacings with the tip growth rate and the cooling rate, respectively, are established.Keywords
This publication has 28 references indexed in Scilit:
- Effects of microstructure and residual stress on fatigue crack growth of stainless steel narrow gap weldsMaterials & Design (1980-2015), 2010
- Mechanical properties of Sn–Zn lead-free solder alloys based on the microstructure arrayMaterials Characterization, 2010
- Dendritic Arm Spacing Affecting Mechanical Properties and Wear Behavior of Al-Sn and Al-Si Alloys Directionally Solidified under Unsteady-State ConditionsMetallurgical and Materials Transactions A, 2010
- The effects of cell spacing and distribution of intermetallic fibers on the mechanical properties of hypoeutectic Al–Fe alloysMaterials Chemistry and Physics, 2010
- Correlation between ultimate tensile strength and solidification microstructure for the sand cast A357 aluminium alloyMaterials & Design (1980-2015), 2009
- Microstructure and electrochemical corrosion behavior of a Pb–1wt%Sn alloy for lead-acid battery componentsJournal of Power Sources, 2009
- The roles of cellular and dendritic microstructural morphologies on the corrosion resistance of Pb–Sb alloys for lead acid battery gridsJournal of Power Sources, 2008
- Design of mechanical properties of a Zn27Al alloy based on microstructure dendritic array spacingMaterials & Design (1980-2015), 2007
- Interdendritic Spacing: Part II. A Comparison of Theory and ExperimentMetallurgical Transactions A, 1984
- Dendrite growth at the limit of stability: tip radius and spacingActa Metallurgica, 1981