Use of Blended Blade and End Wall method in compressor cascades: Definition and mechanism comparisons
Authors:
- Jiabin LiJLJiabin Li
- Xin LiXLXin Li
- Lucheng JiLJLucheng Ji
- Weilin YiWYWeilin Yi
- Ling ZhouLZLing Zhou
- 1 September 2019
- journal article
- research article
- Published by Elsevier in Aerospace Science and Technology
- Vol. 92, 738-749
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (51676015)
This publication has 15 references indexed in Scilit:
- Experimental test of a 3D parameterized vane cascade with non-axisymmetric endwallAerospace Science and Technology, 2019
- Flow separation control using unsteady pulsed suction through endwall bleeding holes in a highly loaded compressor cascadeAerospace Science and Technology, 2018
- The effect of sweep on flowfields of a highly loaded transonic rotorAerospace Science and Technology, 2016
- Competing Three-Dimensional Mechanisms in Compressor FlowsJournal of Turbomachinery, 2016
- Reduction of end wall loss in axial compressor by using non-axisymmetric profiled end wall: A new design approach based on end wall velocity modificationAerospace Science and Technology, 2016
- Experimental Investigation of Endwall and Suction Side Blowing in a Highly Loaded Compressor Stator CascadeJournal of Turbomachinery, 2011
- Three-Dimensional Separations in Axial CompressorsJournal of Turbomachinery, 2005
- The Use of Sweep and Dihedral in Multistage Axial Flow Compressor Blading—Part II: Low and High-Speed Designs and Test VerificationJournal of Turbomachinery, 2002
- The Use of Sweep and Dihedral in Multistage Axial Flow Compressor Blading—Part I: University Research and Methods DevelopmentJournal of Turbomachinery, 2002
- Loss Reduction in Axial-Flow Compressors Through Low-Speed Model TestingJournal of Engineering for Gas Turbines and Power, 1985