Influence of Wire Parameters on Critical Current Versus Strain Characteristics of Bronze Processed ${\hbox {Nb}}_{3}{\hbox {Sn}}$ Superconducting Wires
- 14 December 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 22 (3) , 4805005
Abstract
In order to develop bronze processed Nb3Sn wire for the ITER CS coil operating under higher compressive strain, the influence of various parameters of wires such as filament diameter, barrier materials, barrier thickness, heat treatment pattern and Ti addition on critical current (Ic) versus intrinsic strain εν(-1.0% <; εν <; +0.1%) characteristics was investigated. The change of these parameters brought significant changes to superconducting properties such as Ic and n-value. In spite of different wire parameters, the strain dependency of normalized Ic was almost the same, except that a Ti addition affects the upper critical field Bc2. This result suggests that assuming the same Ti-addition level, Nb3Sn wire with higher performance at a certain εν would exhibit higher performance at any εν in the compressive regime. Based on the result, bronze processed Nb3Sn wires with non-Cu critical current density more than 1100 A/mm2 at 12 T, 4.2 K, zero applied strain have been successfully developed for the CS coil.Keywords
This publication has 13 references indexed in Scilit:
- Fabrication and characterization of internal Sn and bronze-processed Nb3Sn strands for ITER applicationSuperconductor Science and Technology, 2010
- An improved model for the strain dependence of the superconducting properties of Nb3SnSuperconductor Science and Technology, 2008
- Test Results of Two ITER TF Conductor Short Samples Using High Current Density Nb$_{3}$Sn StrandsIEEE Transactions on Applied Superconductivity, 2007
- Relationship between then-value and critical current in Nb3Sn superconducting wires exhibiting intrinsic and extrinsic behaviourSuperconductor Science and Technology, 2005
- Critical current versus strain measurement up to 21T and 1000A of long length superconducting wires and tapesReview of Scientific Instruments, 2005
- Relationship between strain effect and martensitic transformation in multifilamentary Nb3Sn wiresJournal of Applied Physics, 1994
- Resistive transitions and the origin of the n value in superconductors with a Gaussian critical-current distributionJournal of Applied Physics, 1993
- Critical current distributions in superconducting compositesCryogenics, 1986
- Low temperature phase transformation in Nb3Sn multifilamentary wires and the strain dependence of their critical current densityIEEE Transactions on Magnetics, 1981
- Scaling laws for flux pinning in hard superconductorsJournal of Applied Physics, 1973