Microhole Drilling by Double Laser Pulses With Different Pulse Energies
Open Access
- 5 July 2018
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 140 (9) , 091015
Abstract
Previous investigations on “double-pulse” nanosecond (ns) laser drilling reported in the literature typically utilize double pulses of equal or similar pulse energies. In this paper, “double-pulse” ns laser drilling using double pulses with energies differing by more than ten times has been studied, where both postprocess workpiece characterizations and in situ time-resolved shadowgraph imaging observations have been performed. A very interesting physical phenomenon has been discovered under the studied conditions: the “double-pulse” ns laser ablation process, where the low-energy pulse precedes the high-energy pulse (called “low-high double-pulse” laser ablation) by a suitable amount of time, can produce significantly higher ablation rates than “high-low double-pulse” or “single-pulse” laser ablation under a similar laser energy input. In particular, “low-high double-pulse” laser ablation at a suitable interpulse separation time can drill through a ∼0.93 mm thick aluminum 7075 workpiece in less than 200 pulse pairs, while “high-low double-pulse” or “single-pulse” laser ablation cannot drill through the workpiece even using 1000 pulse pairs or pulses, respectively. This indicates that “low-high double-pulse” laser ablation has led to a significantly enhanced average ablation rate that is more than five times those for “single-pulse” or “high-low double-pulse” laser ablation. The fundamental physical mechanism for the ablation rate enhancement has been discussed, and a hypothesized explanation has been given.Keywords
Funding Information
- Directorate for Engineering (CMMI 1266284)
- Directorate for Engineering (CMMI 1300930)
- "Division of Civil, Mechanical and Manufacturing Innovation" (1536306)
- "Division of Civil, Mechanical and Manufacturing Innovation" (CMMI 1266284)
- "Division of Civil, Mechanical and Manufacturing Innovation" (CMMI 1300930)
This publication has 23 references indexed in Scilit:
- Crater geometry characterization of Al targets irradiated by single pulse and pulse trains of Nd:YAG laser in ambient air and waterApplied Surface Science, 2010
- Effect of laser parameters on plasma shielding in single and double pulse configurations during the ablation of an aluminium targetJournal of Physics D: Applied Physics, 2009
- Nonlinear increase in the interaction efficiency of a second pulse with a target upon excitation of a plasma by a train of pulses from a Nd:YAG laserQuantum Electronics, 2009
- Analysis of laser drilled deep holes in stainless steel by superposed pulsed Nd:YAG laser radiationOptics and Lasers in Engineering, 2008
- Laser Drilling in Industrial UsePhotonicsViews, 2008
- Effect of laser pulse energies in laser induced breakdown spectroscopy in double-pulse configurationSpectrochimica Acta Part B: Atomic Spectroscopy, 2005
- Plasma diagnostics during laser ablation in a cavitySpectrochimica Acta Part B: Atomic Spectroscopy, 2003
- Experimental determination of laser induced breakdown thresholds of metals under nanosecond Q-switched laser operationSpectrochimica Acta Part B: Atomic Spectroscopy, 1998
- Physical and material aspects in using visible laser pulses of nanosecond duration for ablationApplied Physics A, 1996
- Physical mechanism of suppression of the emission of radiation by atmospheric gases in a plasma formed as a result of two-pulse irradiation of the surfaceSoviet Journal of Quantum Electronics, 1989