Effect of Counterface Material on Tribological Behavior of AISI 304L Stainless Steel Under Marginally Lubricated Contact
Open Access
- 1 May 2020
- journal article
- Published by Materials Science and Technology Society of Nigeria in Nigerian Journal of Materials Science and Engineering
- Vol. 10 (1) , 30-36
Abstract
The properties of surfaces in contact are known to have significant influence on the tribological behavior of any tribosystem in different contact situations. In the present work, the effect of using different ball counterface material on the tribological behavior of AISI 340L stainless steel under marginally lubricated contact was studied. The frictional behavior was evaluated using a ball-on-flat configuration in reciprocating sliding under marginally lubricated contact condition. 440C stainless steel, Al (2017) alloy and bronze were used as the ball counterface while base-stock synthetic polyalfaolefin oil (PAO10) without additives was used as lubricant. After the friction test, flats and balls surfaces were examined by optical profilometer and optical microscope in order to assess the wear dimension and mechanism. In all the sliding pairs tested at different loads, an initial rapid increase in friction coefficient and a period of transition to a lower steady state friction coefficient were observed. In SS304L-440C pair, wear proportional to applied load occurred in the AISI 340L stainless steel flat by a combination of gross plasticity and abrasion. For both SS304L-Al (2017) and SS304L bronze pairs, severe wear proportional to applied load, which occurred predominantly by abrasive mechanism was observed in the different ball counterface. The study concluded that the types of materials in contact have significant influence on the tribological property of any tribosystem.Keywords
This publication has 20 references indexed in Scilit:
- Tribological behavior of DLC films and duplex ceramic coatings under different sliding conditionsCeramics International, 2018
- 316L stainless steel mechanical and tribological behavior—A comparison between selective laser melting, hot pressing and conventional castingAdditive Manufacturing, 2017
- Effect of bio-lubrication on the tribological behavior of UHMWPE against M30NW stainless steelTribology International, 2016
- Effect of laser surface texturing (LST) on tribochemical films dynamics and friction and wear performanceWear, 2015
- Comparing tribological behaviors of plasma nitrided and untreated bearing steel under lubrication with phosphor and sulfur-free organotungsten additiveTribology International, 2012
- Frictional anisotropy under boundary lubrication: Effect of surface textureWear, 2009
- Effects of multiple treatments of low-temperature colossal supersaturation on tribological characteristics of austenitic stainless steelsWear, 2008
- Friction and wear of coated surfaces — scales, modelling and simulation of tribomechanismsSurface and Coatings Technology, 2007
- Coefficient of friction for aluminum in contact with a carbon fiber epoxy compositeTribology International, 2004
- Effects of steel counterface roughness and temperature on the friction and wear of PE(E)K composites under dry sliding conditionsWear, 1991