Influence of pre-existing stacking fault on the mechanical and microstructural behavior of Cu–Zn alloys—a molecular dynamics study
Open Access
- 4 December 2025
- journal article
- Published by Springer Nature in Journal of King Saud University – Engineering Sciences
- Vol. 37 (8)
Abstract
This study explores the impact of pre-existing stacking fault defects on the mechanical behavior and microstructural evolution of Cu–Zn alloys under uniaxial tensile loading through Molecular Dynamics (MD) simulations. It further examines the influence of varying zinc concentrations (6 at %, 12 at %, and 24 at %) on the alloy’s mechanical properties. The MD simulations are used to evaluate key mechanical parameters, including Young’s modulus, ultimate tensile strength (UTS), and toughness. A detailed comparison of these properties is carried out to identify inherent trends associated with changes in composition. Additionally, the temperature dependence analysis conducted over the range of 200 K to 800 K shows that higher temperatures accelerate failure, reduce UTS, and lower toughness, while system size has a stabilizing effect on stress–strain response. Zn concentration further amplifies these effects, particularly in alloys with pre-existing stacking faults. Complementary to these analyses, Common Neighbor Analysis (CNA) is performed to investigate atomic structural changes within the predominantly FCC solid solution under varying conditions. The results indicate that increasing Zn content in defect-free Cu–Zn alloys leads to a decline in mechanical performance. However, the introduction of pre-existing stacking faults results in a reduction in UTS but an increase in Young’s modulus, suggesting improved resistance to elastic deformation.Keywords
This publication has 33 references indexed in Scilit:
- Temperature-induced different deformation mechanisms for compressive behavior of nanotwinned Cu: molecular dynamics simulationJournal of Nanoparticle Research, 2022
- LAMMPS - a flexible simulation tool for particle-based materials modeling at the atomic, meso, and continuum scalesComputer Physics Communications, 2022
- Molecular dynamics evaluation of the effects of zinc on the mechanical properties of aluminum alloysComputational Materials Science, 2019
- Plastic deformation of FCC alloys at cryogenic temperature: the effect of stacking-fault energy on microstructure and tensile behaviourJournal of Materials Science, 2017
- Effect of stacking fault energy on mechanical properties and strengthening mechanisms of brasses processed by cryorollingMaterials Characterization, 2015
- Enhancement of mechanical properties of low stacking fault energy brass processed by cryorolling followed by short-annealingMaterials & Design (1980-2015), 2015
- Effect of stacking fault energy on mechanical behavior of bulk nanocrystalline Cu and Cu alloysActa Materialia, 2011
- The influence of stacking fault energy on the mechanical behavior of Cu and Cu-Al alloys: Deformation twinning, work hardening, and dynamic recoveryMetallurgical and Materials Transactions A, 2001
- Fast Parallel Algorithms for Short-Range Molecular DynamicsJournal of Computational Physics, 1995
- Slip Systems1991