Impact of light intensity on the polymerization kinetics and network structure of model hydrophobic and hydrophilic methacrylate based dental adhesive resin
- 4 September 2015
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 104 (8) , 1666-1678
Abstract
The impact of light intensity on the degree of conversion (DC), rate of polymerization and network structure was investigated for hydrophobic and hydrophilic dental adhesive resins. Two and three component photoinitiating (PI) systems were used in this study. Low light intensities had a negative impact on the polymerization efficiency for the hydrophilic resin with 2 component PI system. Incorporation of iodonium salt in the hydrophilic resin significantly improved the polymerization efficiency of the HEMA/BisGMA system and led to a substantial DC, even at low light intensities. The results suggested that shorter polymer chains were formed in the presence of iodonium salt. It appears that there is little or no impact of light intensity on the polymer structure of the 2 component PI system. Light intensity has subtle impact on the polymer structure of the 3 component PI system. In the case of the hydrophobic resin, the polymer is so highly cross‐linked that the presence of shorter chains for the 3 component PI system does not cause a decrease in the glass transition temperature (Tg) when compared to the 2 component PI system. For the hydrophilic resin, the presence of shorter polymer chains in the 3 component PI system reduces the Tg when compared with the corresponding 2 component PI system. © 2015 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 104B: 1666–1678, 2016.Keywords
Funding Information
- National Institute of Dental and Craniofacial Research (R01 DE022054, 3R01DE022054-04S1)
- National Institutes of Health, Bethesda, MD
This publication has 37 references indexed in Scilit:
- Quantitative analysis of aqueous phase composition of model dentin adhesives experiencing phase separationJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2012
- Characterization of Micro- and Nanophase Separation of Dentin Bonding Agents by Stereoscopy and Atomic Force MicroscopyMicroscopy and Microanalysis, 2012
- Adhesive/Dentin Interface: The Weak Link in the Composite RestorationAnnals of Biomedical Engineering, 2010
- Enzymatic biodegradation of HEMA/bisGMA adhesives formulated with different water contentJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2008
- Photopolymerization and structure formation of methacrylic acid based hydrogels: The effect of light intensityReactive and Functional Polymers, 2008
- The effect of different light-curing units on tensile strength and microhardness of a composite resinJournal of Applied Oral Science, 2007
- Relationship of solvent to the photopolymerization process, properties, and structure in model dentin adhesivesJournal of Biomedical Materials Research Part A, 2006
- Low‐temperature photopolymerization and post‐cure characteristics of acrylatesPolymer International, 2006
- Characterization of photopolymerization of dentin adhesives as a function of light source and irradianceJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2006
- Calorimetric investigation of polymerization reactions. V. Crosslinked copolymerization of methyl methacrylate with ethylene dimethacrylateJournal of Polymer Science: Polymer Chemistry Edition, 1975