SET D-flip flop design for portable applications
Authors:
- 1 January 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21603162,p. 1-5
Abstract
Increasing demand of portable devices creating larger scope in the field of Low power device design. VLSI designing of the efficient circuits is aiming towards the devices consuming less power and produces less delay with capability to operate in wider range of frequencies. This research paper proposes the modified Single Edge Triggered (SET) D-flip flop design for the low power applications. The earlier proposed design is tested for various substrate bias techniques in sub-threshold region to opt for better design. The overall area of the design is optimized to increase the chip density. Design comparison is performed at 65 nm and 45 nm to show the technology independence. Comparative simulation results show that area and power efficient SET D-FF design is better choice for portable applications.Keywords
This publication has 4 references indexed in Scilit:
- Ultra-low voltage circuits and processor in 180nm to 90nm technologies with a swapped-body biasing technique2004
- Comparative analysis of double-edge versus single-edge triggered clocked storage elements2003
- Comparative analysis of master-slave latches and flip-flops for high-performance and low-power systemsIEEE Journal of Solid-State Circuits, 1999
- Low power design using double edge triggered flip-flopsIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 1994