Selecting and Optimizing a Heat Exchanger for Automotive Vehicle Rankine Cycle Waste Heat Recovery Systems
Authors:
- Helder SantosHSHelder Santos
- Joel MorgadoJMJoel Morgado
- Nuno MartinhoNMNuno Martinho
- João PereiraJPJoão Pereira
- Ana MoitaAna Moita
Open Access
- 1 February 2017
- journal article
- Published by Elsevier in Energy Procedia
- Vol. 107, 390-397
Abstract
No abstract availableThis publication has 13 references indexed in Scilit:
- A review of turbocompounding as a waste heat recovery system for internal combustion enginesRenewable and Sustainable Energy Reviews, 2015
- Heat Transfer in Tubes in the Transitional Flow Regime2014
- Working fluid selection for a subcritical bottoming cycle applied to a high exhaust gas recirculation engineEnergy, 2013
- Review of organic Rankine cycles for internal combustion engine exhaust waste heat recoveryApplied Thermal Engineering, 2013
- Analysis of vehicle exhaust waste heat recovery potential using a Rankine cycleEnergy, 2013
- Effect of inlet geometries and heating on the entrance and fully-developed friction factors in the laminar and transition regions of a horizontal tubeExperimental Thermal and Fluid Science, 2013
- Waste Heat Recovery: The Next Challenge for Commercial Vehicle ThermomanagementSAE International Journal of Commercial Vehicles, 2012
- Comparative design study of a diesel exhaust gas heat exchanger for truck applications with conventional and state of the art heat transfer enhancementsApplied Thermal Engineering, 2010
- Effect of inlet geometry and heating on the fully developed friction factor in the transition region of a horizontal tubeExperimental Thermal and Fluid Science, 1997
- Heat transfer measurements and correlations in the transition region for a circular tube with three different inlet configurationsExperimental Thermal and Fluid Science, 1994