Experimental and Chemical Kinetic Modeling Study of 3-Pentanone Oxidation
- 29 October 2010
- journal article
- research article
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 114 (46) , 12176-12186
Abstract
Shock tube ignition delay times have been measured for 3-pentanone at a reflected shock pressure of 1 atm (±2%), in the temperature range 1250−1850 K, at equivalence ratios of 0.5−2.0 for O2 mixtures in argon with fuel concentrations varying from 0.875 to 1.3125%. Laminar flame speeds have also been measured at an initial pressure of 1 atm over an equivalence ratio range. Complementary to previous studies [Pichon S., Black, G., Chaumeix, N., Yahyaoui, M., Simmie, J. M., Curran, H. J., Donohue, R. Combust. Flame, 2009, 156, 494−504; Serinyel, Z.; Black, G.; Curran, H. J.; Simmie, J. M. Combustion Sci. Tech., 2010, 182, 574−587], laminar flame speeds of 2-butanone have also been measured, and relative reactivities of these ketones have been compared and discussed. A chemical kinetic submechanism describing the oxidation of 3-pentanone has been developed and detailed in this paper; rate constants for unimolecular fuel decomposition reactions have been treated for falloff in pressure with nine-parameter fits using the Troe Formulism. Both compounds treated in this work may be used as fuel tracers, thus further ignition delay time measurements have been carried out by adding 3-pentanone to n-heptane in order to test the effect of the blend on ignition delay timing. It was found that the autoignition characteristics of n-heptane remained unaffected in the presence of 15% 3-pentanone in the fuel, consistent with results obtained using acetone and 2-butanone [Pichon S., Black, G., Chaumeix, N., Yahyaoui, M., Simmie, J. M., Curran, H. J., Donohue, R. Combust. Flame, 2009, 156, 494−504; Serinyel, Z.; Black, G.; Curran, H. J.; Simmie, J. M. Combustion Sci. Tech., 2010, 182, 574−587].Keywords
This publication has 52 references indexed in Scilit:
- Effect of methane-dimethyl ether fuel blends on flame stability, laminar flame speed, and Markstein lengthProceedings of the Combustion Institute, 2011
- Isobutane ignition delay time measurements at high pressure and detailed chemical kinetic simulationsCombustion and Flame, 2010
- The effect of oxygenates on soot formation in rich heptane mixtures: A shock tube studyFuel, 2009
- Experimental and Modeling Study of n-Propylcyclohexane Oxidation under Engine-relevant ConditionsEnergy & Fuels, 2009
- Ethyl Tertiary Butyl Ether Ignition and Combustion Using a Shock Tube and Spherical BombEnergy & Fuels, 2008
- Tracer-LIF diagnostics: quantitative measurement of fuel concentration, temperature and fuel/air ratio in practical combustion systemsProgress in Energy and Combustion Science, 2005
- Extinction and autoignition of n-heptane in counterflow configurationProceedings of the Combustion Institute, 2000
- In-cylinder crank-angle-resolved imaging of fuel concentration in a firing spark-ignition engine using planar laser-induced fluorescenceSymposium (International) on Combustion, 1994
- CHEMACT: A Computer Code to Estimate Rate Constants for Chemically-Activated ReactionsCombustion Science and Technology, 1991
- Chemical Kinetic Data Base for Combustion Chemistry. Part I. Methane and Related CompoundsJournal of Physical and Chemical Reference Data, 1986