Model Updating Concept Using Bridge Weigh-in-Motion Data
Open Access
Abstract
Finite element (FE) model updating of bridges is based on the measured modal parameters and less frequently on the measured structural response under a known load. Until recently, the FE model updating did not consider strain measurements from sensors installed for weighing vehicles with bridge weigh-in-motion (B-WIM) systems. A 50-year-old multi-span concrete highway viaduct, renovated between 2017 and 2019, was equipped with continuous monitoring system with over 200 sensors, and a B-WIM system. In the most heavily instrumented span, the maximum measured longitudinal strains induced by the full-speed calibration vehicle passages were compared with the modelled strains. Based on the sensitivity study results, three variables that affected its overall stiffness were updated: Young’s modulus adjustment factor of all structural elements, and two anchorage reduction factors that considered the interaction between the superstructure and non-structural elements. The analysis confirmed the importance of the initial manual FE model updating to correctly reflect the non-structural elements during the automatic nonlinear optimisation. It also demonstrated a successful use of pseudo-static B-WIM loading data during the model updating process and the potential to extend the proposed approach to using random B-WIM-weighed vehicles for FE model updating and long-term monitoring of structural parameters and load-dependent phenomena.Keywords
Funding Information
- The Slovenian Research and Innovation Agency (P2-0260, P2-0273, I0-0032, 53694)
This publication has 28 references indexed in Scilit:
- Cyclic response of I-shaped bridge columns with substandard transverse reinforcementEngineering Structures, 2015
- Bridge Damage Detection Using Weigh-in-Motion TechnologyJournal of Bridge Engineering, 2015
- Introduction2014
- Effective Prestressing Force Testing Method of External Prestressed Bridge Based on Frequency MethodApplied Mechanics and Materials, 2013
- Finite element model updating of a bowstring-arch railway bridge based on experimental modal parametersEngineering Structures, 2012
- Assignment of structural behaviours in long-term monitoring: Application to a strengthened railway bridgeStructural Health Monitoring, 2012
- Progressive finite element model calibration of a long-span suspension bridge based on ambient vibration and static measurementsEngineering Structures, 2010
- Improved bridge evaluation through finite element model updating using static and dynamic measurementsEngineering Structures, 2009
- Damage Detection of a Prestressed Concrete Beam Using Modal StrainsJournal of Structural Engineering, 2005
- Structural Finite Element Model Updating Using Ambient Vibration Test ResultsJournal of Structural Engineering, 2005