The Effect of Striking Angle on the Buckling Mechanism in Blowout Fracture
Authors:
- Tomohisa NagasaoTNTomohisa Nagasao
- Tatsuo NakajimaTNTatsuo Nakajima
- 1 June 2006
- journal article
- research article
- Published by Wolters Kluwer Health in Plastic and Reconstructive Surgery
- Vol. 117 (7) , 2373-2380
Abstract
Background: The buckling mechanism is widely accepted as a mechanism of blowout fractures, along with the hydraulic mechanism. Although many studies have been performed related to the buckling mechanism, none of them have taken the direction of the striking force into consideration. As the orbital floor is not parallel to the horizontal plane, a difference in the striking force direction might affect resultant fracture patterns. The present study aims to investigate whether fracture patterns in the orbital floor were influenced by the striking force direction in terms of the buckling mechanism. Methods: The authors produced three-dimensional models on a workstation simulating eight dry skulls and applied striking forces on the orbital rim of each model from three different angles (0, 15, and 30 degrees in the upward direction). Using finite element analysis, the authors calculated the width of the area where the resultant stresses exceed the bone's yielding criterion. The width was termed the “theoretical fracture width” because, theoretically, fracture was expected to occur in the area. Then, the authors compared the theoretical fracture width in groups with the three different striking force angles. Finally, the validity of the theoretical width was verified with an experiment on actual skull models. Results: The theoretical fracture width was the greatest when the striking force was directed at 30 degrees in the upward direction. Conclusions: For the buckling mechanism, fracture would occur in a wider area of the orbital floor when striking force was directed upward than when the force was horizontally directed. This finding would be helpful in predicting fracture width in blowout fractures.Keywords
This publication has 15 references indexed in Scilit:
- An investigation into the mechanism of orbital blowout fracturesBritish Journal of Plastic Surgery, 1999
- Presurgical Finite Element Analysis from Routine Computed Tomography Studies for Craniofacial Distraction: II. An Engineering Prediction Model for Gradual Correction of Asymmetric Skull DeformitiesPlastic and Reconstructive Surgery, 1998
- Pre-surgical CT/FEA for craniofacial distraction: I.: Methodology, development, and validation of the cranial finite element model1 Presented at the Plastic Surgery Research Council Galveston, TX, 28 February 1997 and the American Society of Plastic and Reconstructive Surgery San Francisco, CA, 22 September 1997.1Medical Engineering & Physics, 1998
- Force Necessary to Fracture the Orbital FloorOphthalmic Plastic & Reconstructive Surgery, 1990
- EXPERIMENTAL “BLOWOUT” FRACTURE OF THE ORBITPlastic and Reconstructive Surgery, 1974
- MECHANISM OF ORBITAL BLOWOUT FRACTUREThe Keio Journal of Medicine, 1974
- MECHANISM OF ORBITAL BLOWOUT FRACTUREThe Keio Journal of Medicine, 1974
- “Blow-out” Fractures of the Orbit: An Investigation into their Anatomical BasisThe Journal of Laryngology & Otology, 1967
- Blow-Out Fracture of the OrbitAmerican Journal of Ophthalmology, 1957
- TRAUMATIC ENOPHTHALMOSArchives of Ophthalmology (1950), 1943