Triboelectric Performance and Post-Contact Transient Response of Triglyceride–Sulfur Copolymer Paired with Waste-Derived Materials
Authors:
- Petr SlobodianPetr Slobodian
- Jiří MatyášJMJiří Matyáš
- Robert OlejníkRORobert Olejník
- Berenika HausnerováBHBerenika Hausnerová
- María Luz RovattaMaría Luz Rovatta
- Gustavo MontiGMGustavo Monti
- Diego Fernando AcevedoDiego Fernando Acevedo
- César Alfredo BarberoCésar Alfredo Barbero
- Marek JurčaMJMarek Jurča
- Martin NovákMNMartin Novák
- Markéta SádeckáMSMarkéta Sádecká
Open Access
- 25 October 2026
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 17 (11) , 1224
Abstract
Triboelectric nanogenerators (TENGs) provide a simple approach for converting mechanical excitation into electrical signals through contact electrification and electrostatic induction. In this work, a triglyceride–sulfur copolymer (TGS), prepared by inverse vulcanization of elemental sulfur with soybean oil, was investigated with two waste-derived counter materials: recycled residual waste plastic (RRWP) and waste goatskin leather (WGL). The TGS–RRWP and TGS–WGL pairs exhibited opposite electrical polarities, with triboelectric charge densities of approximately +41.3 µC m−2 for TGS–RRWP and −56.0 µC m−2 for TGS–WGL, where the sign refers to the charge measured on the TGS electrode. Repeated contact–separation cycling showed an initial conditioning period followed by stabilization of the electrical response. Load-dependent measurements at 1 and 10 Hz revealed maximum output power at approximately 2–4 MΩ, reaching about 2.7 mW for TGS–RRWP and 1.8 mW for TGS–WGL at 10 Hz. Post-contact measurements further revealed reproducible voltage transients after circuit closure while the mechanically conditioned layers remained in static contact. Biexponential fitting showed that the faster decay time increased approximately linearly with effective load resistance, corresponding to apparent effective system capacitances of about 69 pF for TGS–RRWP and 44 pF for TGS–WGL, measured using a high-impedance differential probe to minimize measurement-induced loading, although residual parasitic contributions cannot be excluded. These results demonstrate opposite triboelectric polarity, load-dependent energy conversion, and a reproducible post-contact transient response with a substantial RC contribution.Keywords
Funding Information
- European Union under the OP Jan Amos Comenius (CZ.02.01.01/00/23_021/0010411)
- Ministry of Education, Youth, and Sports of the Czech Republic (RP/CPS/2024-28/005)
This publication has 31 references indexed in Scilit:
- Triboelectric performance and delayed charge generation in triglyceride–sulfur synthesized from waste sourcesChemical Engineering Journal, 2026
- Mechano-electric conversion of biaxially oriented polypropylene films from plastics-packaging waste sourcesChemical Engineering Journal, 2025
- Turning Plastic Waste Immiscibility into an Advantage: Efficiency Improvement of PVDF‐Based Energy Harvesters Using Post‐Consumer ThermoplasticsAdvanced Materials Interfaces, 2025
- Adding Value into Elementary Sulfur for Sustainable MaterialsChemistry – A European Journal, 2025
- High‐Performance Yet Sustainable Triboelectric Nanogenerator Based on Sulfur‐Rich Polymer Composite with MXene Segregated StructureAdvanced Materials, 2024
- Recyclable waste derived green triboelectric nanogenerator for Self-Powered synthesis of Defect-Free graphene via Mechano-Electrochemical exfoliationChemical Engineering Journal, 2023
- A novel triboelectric nanogenerator based on only food packaging aluminium foilsMaterials Letters, 2022
- Novel Recycled Triboelectric Nanogenerator Based on Polymer‐Coated Trash Soda Can for Clean Energy HarvestingAdvanced Sustainable Systems, 2021
- A triboelectric nanogenerator based on waste plastic bags for flexible vertical interconnection systemMicrosystem Technologies, 2020
- Synthesis and Applications of Polymers Made by Inverse VulcanizationTopics in Current Chemistry, 2019