Development of JEDEC standard thermal measurement test boards
Author:
- 24 December 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 183-190
Abstract
A combination of experimental and modeling studies has been performed to define the impact of printed circuit board (PCB) design on the measured thermal performance of IC packages. These results have been used to develop a JEDEC test card standard that allows less than 10% measurement variability between the minimum and maximum limits of the design parameters. At the same time, the standard allows wide latitude in layout for various components. The modelling and measurement studies that were performed to set the limits of the standard test coupons for surface mounted components and area array packages such as ball grid arrays (BGAs) will be described, along with extensions in principle to actual devices operating in systems.Keywords
This publication has 7 references indexed in Scilit:
- Use of experimental data in guiding thermal specification development2002
- Thermal enhancement of IC packages2002
- Experimental determination of the effect of printed circuit card conductivity on the thermal performance of surface mount electronic packages2002
- Development, validation and application of a thermal model of a plastic quad flat pack2002
- Effect on observed package thermal performance of system board metal content2002
- A novel approach for the thermal characterization of electronic parts2002
- Analysis of a thermally enhanced ball grid array package2002