An improved method for evaluating the rotational speed stability of a hydro-viscous clutch in mixed lubrication
Authors:
Open Access
- 5 January 2015
- journal article
- Published by Tsinghua University Press in Friction
- Vol. 3 (1) , 47-55
Abstract
Rotational speed stability is an important evaluation indicator of the performance of a hydro-viscous clutch (HVC). To improve the rotational speed stability of HVCs in mixed lubrication and the running condition of the friction pairs, the speed stability of an HVC in mixed lubrication was studied. To this end, the friction coefficients of both copper-based and paper-based friction pairs were experimentally tested using an MM1000-III wet friction machine. Theoretically, a torsional vibration model of the system is presented. The phase plane analysis method is applied to evaluate the stability of the torsional vibration model, where a critical negative gradient (CNG) is defined. The results show that the friction coefficient in mixed lubrication is an important parameter for the stability of the rotational speed. The system will be unstable when the negative gradient of the friction coefficient-slip speed is larger than the CNG. According to the definition of the CNG, suggestions regarding choice of friction pairs are made to improve the rotational speed stability of an HVC in mixed lubrication.Keywords
This publication has 13 references indexed in Scilit:
- Effects of groove on behavior of flow between hydro-viscous drive platesJournal of Central South University, 2012
- Film Thickness and Asperity Load Formulas for Line-Contact Elastohydrodynamic Lubrication With Provision for Surface RoughnessJournal of Tribology, 2012
- Clutch Parameter Effects on Torque and Friction StabilitySAE International Journal of Advances and Current Practices in Mobility, 2011
- On the Behavior of Friction in Lubricated Point Contact With Provision for Surface RoughnessJournal of Tribology, 2009
- An Experimental Investigation of Dimple Effect on the Stribeck Curve of Journal BearingsTribology Letters, 2007
- Simulations and Measurements of Sliding Friction Between Rough Surfaces in Point Contacts: From EHL to Boundary LubricationJournal of Tribology, 2007
- The Stribeck Curve: Experimental Results and Theoretical PredictionJournal of Tribology, 2006
- Modeling and Parametric Study of Torque in Open Clutch PlatesJournal of Tribology, 2005
- A Computer Thermal Model of Mixed Lubrication in Point ContactsJournal of Tribology, 2004
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978