Assessment of modal pushover analysis and conventional nonlinear static procedure with load distributions of federal emergency management agency for high‐rise buildings
Authors:
- 31 October 2008
- journal article
- research article
- Published by Wiley in The Structural Design of Tall and Special Buildings
- Vol. 19 (3) , 291-308
Abstract
The nonlinear static pushover analysis technique is mostly used in the performance‐based design of structures. However, the pushover analysis with load distributions of Federal Emergency Management Agency (FEMA) loses its accuracy in estimating the seismic responses of long‐period structures where higher mode effects are important. Recently, modal pushover analysis (MPA) has been proposed to consider these effects. Hence, FEMA load patterns and MPA are evaluated in the current study and compared with inelastic response history analysis. These approximate procedures are applied to medium‐rise (10 and 15 stories) and high‐rise (20 and 30 stories) buildings; advantages and limitations of them are elaborated. It is shown that MPA procedure presents significant advantage over FEMA load distributions in predicting story drifts. MPA is able to compute hinge plastic rotations better than FEMA load distributions at upper floor levels of high‐rise buildings due to considering higher mode effects by this procedure, but both are unsuccessful in predicting hinge plastic rotations with acceptable accuracy. Copyright © 2008 John Wiley & Sons, Ltd.Keywords
This publication has 14 references indexed in Scilit:
- DEVELOPMENT AND VERIFICATION OF A DISPLACEMENT-BASED ADAPTIVE PUSHOVER PROCEDUREJournal of Earthquake Engineering, 2004
- Evaluation of a Modified MPA Procedure Assuming Higher Modes as Elastic to Estimate Seismic DemandsEarthquake Spectra, 2004
- ADVANTAGES AND LIMITATIONS OF ADAPTIVE AND NON-ADAPTIVE FORCE-BASED PUSHOVER PROCEDURESJournal of Earthquake Engineering, 2004
- Evaluation of Modal and FEMA Pushover Analyses: SAC BuildingsEarthquake Spectra, 2004
- An Incremental Response Spectrum Analysis Procedure Based on Inelastic Spectral Displacements for Multi-Mode Seismic Performance EvaluationBulletin of Earthquake Engineering, 2003
- A modal pushover analysis procedure for estimating seismic demands for buildingsEarthquake Engineering & Structural Dynamics, 2001
- A Nonlinear Analysis Method for Performance‐Based Seismic DesignEarthquake Spectra, 2000
- Adaptive Spectra‐Based Pushover Procedure for Seismic Evaluation of StructuresEarthquake Spectra, 2000
- Seismic Performance and Retrofit Evaluation of Reinforced Concrete StructuresJournal of Structural Engineering, 1997
- THE N2 METHOD FOR THE SEISMIC DAMAGE ANALYSIS OF RC BUILDINGSEarthquake Engineering & Structural Dynamics, 1996