Optical fibre switches based on full wafer silicon micromachining
Authors:
- 1 January 1999
- journal article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 9 (2) , 151-155
Abstract
An optical (1 × 2) moving-fibre switch with bistable operation is presented. The low cost fabrication process based on bulk anisotropic Si etching for thermal actuators with cross sections of 80 × 150 µm2 is described. V-grooves are used for a precise alignment of the optical fibres. Switches and switch arrays are fabricated with high yield and high mechanical stability. An insertion loss of 2 dB including MT-connector losses and a cross talk below the detection limit (-60 dB) are measured. The thermally driven actuators operate with a power <700 mW which is, due to the bistable operation, needed for 100 ms only.Keywords
This publication has 8 references indexed in Scilit:
- Micromachining of plates in oriented siliconJournal of Micromechanics and Microengineering, 1998
- Thermooptical digital switch arrays in silica-on-silicon with defined zero-voltage stateJournal of Lightwave Technology, 1998
- All-silicon bistable micromechanical fibre switchesElectronics Letters, 1998
- (2×2) digital optical switch realised by lowcostpolymer waveguide technologyElectronics Letters, 1996
- Micromachined 1 × 2 optical-fiber switchSensors and Actuators A: Physical, 1996
- Micro-opto mechanical switchintegrated on siliconElectronics Letters, 1995
- Etching front control of strips for corner compensationSensors and Actuators A: Physical, 1993
- Silicon as a mechanical materialProceedings of the IEEE, 1982