High precision signal processing algorithm to evaluate the SAW properties as a function of temperature
Authors:
- Leonhard ReindLeonhard Reind
- Jochen BardongJBJochen Bardong
- 1 September 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 863-866
Abstract
In order to measure the temperature using Surface Acoustic Wave (SAW) devices, it is important to characterize the substrate material over a desired temperature range, which strongly depends on the accuracy of the analysis algorithm used. This paper presents a special signal processing algorithm, which accurately evaluates the desired SAW properties as functions of temperature. The analysis algorithm is performed in two steps. In the first step, the algorithm determines the center frequency of the delay lines and obtains the delay time difference by cross correlating the signals out of the short and long delay lines. The extracted parameters are then used in a second analysis step to calculate the acoustic properties of the SAW material as a function of temperature. To validate this algorithm, its accuracy is studied.Keywords
This publication has 6 references indexed in Scilit:
- SAW-relevant material properties of langasite in the temperature range from 25 to 750 °C: New experimental results2008
- Precise measurements of BAW and SAW properties of Langasite in the temperature range from 25°C to 1000°C2008
- Investigation on SAW properties of LGS and optimal cuts for high-temperature applicationsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2005
- Properties of radio frequency rayleigh waves on langasite at elevated temperatures2005
- A review of langasite material constants from BAW and SAW data: toward an improved data set2002
- Optimal cuts of langasite, La/sub 3/Ga/sub 5/SiO/sub 14/ for SAW devicesIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2001