A Single-Chip Full-Duplex High Speed Transceiver for Multi-Site Stimulating and Recording Neural Implants
- 12 October 2015
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 10 (3) , 643-653
Abstract
We present a novel, fully-integrated, low-power full-duplex transceiver (FDT) to support high-density and bidirectional neural interfacing applications (high-channel count stimulating and recording) with asymmetric data rates: higher rates are required for recording (uplink signals) than stimulation (downlink signals). The transmitter (TX) and receiver (RX) share a single antenna to reduce implant size and complexity. The TX uses impulse radio ultra-wide band (IR-UWB) based on an edge combining approach, and the RX uses a novel 2.4-GHz on-off keying (OOK) receiver. Proper isolation (>20 dB) between the TX and RX path is implemented 1) by shaping the transmitted pulses to fall within the unregulated UWB spectrum (3.1-7 GHz), and 2) by space-efficient filtering (avoiding a circulator or diplexer) of the downlink OOK spectrum in the RX low-noise amplifier. The UWB 3.1-7 GHz transmitter can use either OOK or binary phase shift keying (BPSK) modulation schemes. The proposed FDT provides dual band 500-Mbps TX uplink data rate and 100 Mbps RX downlink data rate, and it is fully integrated into standard TSMC 0.18- μm CMOS within a total size of 0.8 mm 2 . The total measured power consumption is 10.4 mW in full duplex mode (5 mW at 100 Mbps for RX, and 5.4 mW at 500 Mbps or 10.8 pJ/bit for TX). Additionally, a 3-coil inductive link along with on-chip power management circuits allows to powering up the implantable transceiver wirelessly by delivering 25 mW extracted from a 13.56-MHz carrier signal, at a total efficiency of 41.6%.Keywords
This publication has 38 references indexed in Scilit:
- A Minimally Invasive 64-Channel Wireless μECoG ImplantIEEE Journal of Solid-State Circuits, 2014
- BER performance of implant-to-air high-speed UWB data communications for neural recording systems2018 40th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (EMBC), 2014
- A low-power 2.4-GHz receiver for wireless implantable neural stimulators2014
- A chronic generalized bi-directional brain–machine interfaceJournal of Neural Engineering, 2011
- An Integrated 256-Channel Epiretinal ProsthesisIEEE Journal of Solid-State Circuits, 2010
- Optimization of Data Coils in a Multiband Wireless Link for Neuroprosthetic Implantable DevicesIEEE Transactions on Biomedical Circuits and Systems, 2010
- High-Speed OQPSK and Efficient Power Transfer Through Inductive Link for Biomedical ImplantsIEEE Transactions on Biomedical Circuits and Systems, 2010
- Distributed Waveform Generator: A New Circuit Technique for Ultra-Wideband Pulse Generation, Shaping and ModulationIEEE Journal of Solid-State Circuits, 2009
- Gain-Enhancement Techniques for CMOS Folded Cascode LNAs at Low-Voltage OperationsIEEE Transactions on Microwave Theory and Techniques, 2008
- A 1.2 V Reactive-Feedback 3.1–10.6 GHz Low-Noise Amplifier in 0.13 $\mu{\hbox {m}}$ CMOSIEEE Journal of Solid-State Circuits, 2007