Modelling the performance of the vernier hybrid machine
Authors:
- 7 November 2003
- journal article
- Published by Institution of Engineering and Technology (IET) in IEE Proceedings - Electric Power Applications
- Vol. 150 (6) , 647-654
Abstract
Variable reluctance permanent magnet machines exhibit shear stresses higher than conventional machine topologies. However, analysis and design of these machine topologies is not straightforward owing to the nature of the flux paths in the machine. In a transverse flux machine flux flows in all three dimensions and the machine structure is non-conventional. The vernier hybrid machine is another member of this family, but the flux paths are restricted to two dimensions, and can therefore be constructed using laminations. Significant leakage flux paths exist in the vernier hybrid machine, which must be modelled accurately during machine design. The use of flux-linkage maps to determine the performance of a linear vernier hybrid machine is described. Experimental results are presented to verify the model. The technique can be applied to any variable reluctance permanent magnet machine topology.Keywords
This publication has 7 references indexed in Scilit:
- A low speed reciprocating permanent magnet generator for direct drive wave energy converters2002
- Comments on "Energy stored in permanent magnets"IEEE Transactions on Magnetics, 2000
- The flux-reversal machine: a new brushless doubly-salient permanent-magnet machineIEEE Transactions on Industry Applications, 1997
- Prediction of cogging torque using the flux-MMF diagram techniqueIEEE Transactions on Industry Applications, 1996
- Torque prediction using the flux-MMF diagram in AC, DC, and reluctance motorsIEEE Transactions on Industry Applications, 1996
- A novel high-torque reluctance motor with rare-earth magnetIEEE Transactions on Industry Applications, 1994
- Brushless permanent-magnet motor drivesPower Engineering Journal, 1988