The Effect of Fuel Injection Location on Supersonic Hydrogen Combustion in a Cavity-Based Model Scramjet Combustor
Open Access
Abstract
Supersonic combustion experiments were performed using three different hydrogen fuel-injection configurations in a cavity-based model scramjet combustor with various global fuel–air equivalence ratios. The configurations tested were angled injection at 15° to the flow direction upstream of the cavity, parallel injection from the front step, and upstream injection from the rear ramp. Planar laser-induced fluorescence of the hydroxyl radical and time-resolved pressure measurements were used to investigate the flow characteristics. Angled injection generated a weak bow shock in front of the injector and recirculation zone to maintain the combustion as the equivalence ratio increased. Parallel and upstream injections both showed similar flame structure over the cavity at low equivalence ratio. Upstream injection enhanced the fuel diffusion and enabled ignition with a shorter delay length than with parallel injection. The presence of a flame near the cavity was determined while varying the fuel injection location, the equivalence ratio, and total enthalpy of the air flow. The flame characteristics agreed with the correlation plot for the stable flame limit of non-premixed conditions. The pressure increase in the cavity for reacting flow compared to non-reacting flow was almost identical for all three configurations. More than 300 mm downstream of the duct entrance, averaged pressure ratios at low global equivalence ratio were similar for all three injection configurations.Keywords
This publication has 29 references indexed in Scilit:
- Cavity Flame-Holders for Ignition and Flame Stabilization in Scramjets: An OverviewJournal of Propulsion and Power, 2001
- Mixing of a Sonic Transverse Jet Injected into a Supersonic FlowAIAA Journal, 2000
- Wall Pressure Measurements for a Sonic Jet Injected Transversely into a Supersonic CrossflowJournal of Propulsion and Power, 1998
- Comparison of Physical and Aerodynamic Ramps as Fuel Injectors in Supersonic FlowJournal of Propulsion and Power, 1998
- Complete three-dimensional multiparameter mapping of a supersonic ramp fuel injector flowfieldAIAA Journal, 1996
- Vortex generation and mixing in three-dimensional supersonic combustorsJournal of Propulsion and Power, 1995
- Investigation of scramjet injection strategies for high Mach number flowsJournal of Propulsion and Power, 1995
- Experimental investigation of a supersonic swept ramp injector using laser-induced iodine fluorescenceJournal of Propulsion and Power, 1994
- Experimental supersonic hydrogen combustion employing staged injection behind a rearward-facing stepJournal of Propulsion and Power, 1993
- Supersonic flow over a rearward facing step with transverse nonreacting hydrogen injectionAIAA Journal, 1983