Experimental investigation of phase change material energy storage system integrated with thermoelectric generator under transient heat loads
Authors:
- 26 July 2022
- journal article
- research article
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 44 (3) , 6793-6806
Abstract
Thermoelectric generator (TEG) systems are often exposed to unstable heat loads with transient temperature boundary conditions. TEG behavior recognition in thermal fluctuations is necessary to increase its efficiency and protection. This research deals with the experimental study of thermoelectric module’s performance under transient thermal boundary conditions. Therefore, three types of novel prototypes of transient heat loads including rectangular, triangular, and sinusoidal were suggested. Also, a phase change material (PCM) was applied inside an aluminum box on the hot side of the module. In the mentioned system, the effect of PCM on the module performance in the unstable heat loads was investigated. Applying PCM led to the protecting the module against temperature fluctuations, storing the energy, and generating effective voltage for a long time after turning the heat source off. Voltage generation lasted for 59.5 min with 90 W input power in 3-min periods in the rectangular heat load. Meanwhile, after switching the heaters off, 42.8- and 50-min voltages were received from triangular and sinusoidal loads, respectively, each with the power ranging from 0 to 90 W in four periods, lasted for 3 min.Keywords
This publication has 30 references indexed in Scilit:
- A Novel Structure for Heat Transfer Enhancement in Phase Change Composite: Rolled Graphene Film Embedded in Graphene FoamACS Applied Energy Materials, 2019
- Effect of engine exhaust gas pulsations on the performance of a thermoelectric generator for wasted heat recovery: An experimental and analytical investigationEnergy, 2018
- Protection and thermal management of thermoelectric generator system using phase change materials: An experimental investigationEnergy, 2018
- Experimentation, Validation, and Uncertainty Analysis for Engineers2018
- Development of a hybrid solar thermal system with TEG and PEM electrolyzer for hydrogen and power productionInternational Journal of Hydrogen Energy, 2017
- Integrating Phase-Change Materials into Automotive Thermoelectric GeneratorsJournal of Electronic Materials, 2014
- Design and Fabrication of Heat Storage Thermoelectric Harvesting DevicesIEEE Transactions on Industrial Electronics, 2013
- Thermoelectric energy harvesting from diurnal heat flow in the upper soil layerEnergy Conversion and Management, 2012
- Optimization of Phase Change Material Heat Sinks for Low Duty Cycle High Peak Load Power SuppliesIEEE Transactions on Components, Packaging and Manufacturing Technology, 2011
- Review on thermal energy storage with phase change: materials, heat transfer analysis and applicationsApplied Thermal Engineering, 2003