Heat Transfer and Pressure Drop Characteristics of Graphene Oxide/Water Nanofluid in a Circular Tube Fitted with Wire Coil Insert
Authors:
- 29 September 2014
- journal article
- research article
- Published by Taylor & Francis in Experimental Heat Transfer
- Vol. 29 (2) , 173-187
Abstract
In this work, heat transfer and pressure drop characteristics of graphene oxide/water nanofluid flow through a circular tube having a wire coil insert were studied. The required graphene oxide was synthesized via the Hummer method and characterized using Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (SRD), and scanning electron microscope (SEM) methods. Dispersing graphene oxide in the water, nanofluids with 0.02, 0.07, and 0.12% volume fraction were prepared. An experimental set-up was designed and made to investigate the heat transfer performance and pressure loss of nanofluids. All experiments were carried out in the constant heat flux at tube wall conditions. The volumetric flow rates of the nanofluid were adjusted at 6, 8, and 10 L/min. Thermal conductivity, specific heat, density, and viscosity as thermophysical properties of the nanofluid were calculated using graphene oxide and water properties at the average temperature via appropriate relations. These properties were applied to calculate the convective heat transfer coefficient, Nusselt number, and friction factors for each experiment. Finally, the constant and exponents of Duangthongsuk and Wongwises's correlations for Nusselt number and friction factor were corrected by experimental results. The achieved experimental data have shown good agreement with those predicted. The results have shown that 0.12 vol% of graphene oxide in the water can enhance convective heat transfer coefficient by about 77%. As a result, it can be concluded that the graphene oxide/water can be used in the heat transfer devices to achieve more efficiency.Keywords
This publication has 19 references indexed in Scilit:
- Experimental analysis of heat transfer and friction factor of nanofluid as a coolant in a corrugated plate heat exchangerExperimental Thermal and Fluid Science, 2012
- Heat transfer enhancement by using CuO/water nanofluid in corrugated tube equipped with twisted tapeInternational Communications in Heat and Mass Transfer, 2012
- Comparison of the thermal performances of two nanofluids at low temperature in a plate heat exchangerExperimental Thermal and Fluid Science, 2011
- Enhanced convective heat transfer using graphene dispersed nanofluidsDiscover Nano, 2011
- Heat transfer enhancements of low volume concentration Al2O3 nanofluid and with longitudinal strip inserts in a circular tubeInternational Journal of Heat and Mass Transfer, 2010
- An experimental investigation of forced convective cooling performance of a microchannel heat sink with Al2O3/water nanofluidApplied Thermal Engineering, 2010
- Convective Heat Transfer of a Cu/Water Nanofluid Flowing Through a Circular TubeExperimental Heat Transfer, 2009
- Heat transfer enhancement and pressure drop characteristics of TiO2–water nanofluid in a double-tube counter flow heat exchangerInternational Journal of Heat and Mass Transfer, 2009
- Experimental studies on heat transfer and friction factor characteristics of turbulent flow through a circular tube fitted with regularly spaced helical screw-tape insertsApplied Thermal Engineering, 2007
- Preparation of Graphitic OxideJournal of the American Chemical Society, 1958