Investigation of Novel Nano-carbide WC/CoCr Coatings Applied by HVAF
Authors:
Open Access
- 15 May 2023
- journal article
- research article
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 32 (6) , 1772-1779
Abstract
Wear leads to high material and energy losses in various industries. The manufacturing of novel nano-carbide WC/CoCr powder feedstock materials promises a further increase in the performance of thermally sprayed wear protection coatings. A novel experimental powder and a commercial ultra-fine carbide WC/CoCr reference are thermally sprayed onto a 1.0038 substrate by High Velocity Air Fuel (HVAF) spraying. The specimens are metallographically prepared and analyzed by means of light microscopy (LM) and scanning electron microscopy (SEM). Vickers Hardness testing is conducted by micro-indentation, and the porosities are determined by optical image analysis. X-ray diffractometry (XRD) analysis is used to investigate the phase retention. Fine nanocrystalline WC structures are preserved in the dense coatings. A significant effect of powder type on the porosity of the coating was found. No systematic relationships could be identified between the coating structure and the two parameter settings. It was possible to influence decarburization via both the powder type and the selected parameters. The resulting experimental and commercial nanostructured WC/CoCr coatings exhibit high, narrow hardness values with medians of 1.400 < HV0.3 < 1.470. The novel nanostructured coating can contribute to reduced wear and therefore improve the efficient utilization of critical raw materials like tungsten.Keywords
Funding Information
- RWTH Aachen University
This publication has 15 references indexed in Scilit:
- A comparative study on the microstructure and surface property evaluation of coatings produced from nanostructured and conventional WC–Co powders HVOF-sprayed on Al7075Surface and Coatings Technology, 2015
- Microstructural characterization of HVOF/plasma thermal spray of micro/nano WC–12%Co powdersSurface and Coatings Technology, 2015
- HVOF-sprayed WC–CoCr coatings on Al alloy: Effect of the coating thickness on the tribological propertiesWear, 2009
- Parametric Study of an HVOF Process for the Deposition of Nanostructured WC-Co CoatingsJournal of Thermal Spray Technology, 2005
- Effect of carbide grain size on microstructure and sliding wear behavior of HVOF-sprayed WC–12% Co coatingsWear, 2003
- Microstructural evolution in thermally sprayed WC–Co coatings: comparison between nanocomposite and conventional starting powdersActa Materialia, 2000
- Microstructure and Properties of Tungsten Carbide Coatings Sprayed with Various High-Velocity Oxygen Fuel Spray SystemsJournal of Thermal Spray Technology, 1999
- Abrasive wear behaviour of conventional and nanocomposite HVOF-sprayed WC–Co coatingsWear, 1999
- Fracture toughness and crack morphologies in eroded WC–Co–Cr thermally sprayed coatingsMaterials Letters, 1998
- Comparative Study of WC-Cermet Coatings Sprayed via the HVOF and the HVAF ProcessJournal of Thermal Spray Technology, 1998