Triaxial Testing Techniques and Sand Liquefaction
Authors:
- 1 January 1978
- book chapter
- Published by ASTM International
- p. 265-279
Abstract
This investigation examines effects of specimen preparation and testing techniques, that is, loading wave form, degree of saturation, and density variations, on the liquefaction behavior of Monterey No. 0 sand under cyclic loading. The test results indicate that specimen preparation greatly affects the cyclic strength. Specimens prepared moist were 38 to 58 percent stronger than specimens of comparable density prepared dry. Also, specimens prepared using a procedure of undercompaction were approximately 10 percent stronger than comparable specimens prepared without using variable compaction. Loading wave form, as well, affected cyclic strength, with sinusoidal wave forms exhibiting strengths 15 percent stronger than triangular-shaped and 30 percent stronger than rectangular-shaped loading wave forms. An increase in density of 20 kg/m3 (1.2 lb/ft3) caused a 22 to 30 percent increase in strength. The results showed that changing the diameter of the compaction foot from 0.95 cm (0.375 in.) to 3.56 cm (1.4 in.) or the molding water content from 12.8 percent to 8.0 percent, or testing specimens after a B-value of either 0.98 or 0.91 had been obtained, had no significant effect on the cyclic strength of specimens.Keywords
This publication has 5 references indexed in Scilit:
- Effects of Sample Preparation on Sand LiquefactionJournal of the Geotechnical Engineering Division, 1977
- Cyclic Triaxial Strength of Standard Test SandJournal of the Geotechnical Engineering Division, 1976
- Pneumatic Sinusoidal Loading SystemJournal of the Geotechnical Engineering Division, 1976
- Specimen Preparation and Liquefaction of SandsJournal of the Geotechnical Engineering Division, 1974
- Saturating Laboratory Samples by Back PressureJournal of the Soil Mechanics and Foundations Division, 1973