Indication of the radiofrequency induced lesion size by pre-ablation measurements
Authors:
- H PetersenHPH Petersen
- X ChenXCX Chen
- J SvendsenJSJ Svendsen
- 1 November 2005
- journal article
- Published by Oxford University Press (OUP) in EP Europace
- Vol. 7 (6) , 525-534
Abstract
During radiofrequency ablation of arrhythmias tissue heating and hence lesion size depend on electrode-tissue contact and cooling of the electrode tip caused by cavitary blood flow. These factors are unique and unknown for each catheter placement in the beating heart. A tool for assessing these factors prior to ablation may indicate the lesion size which will be obtained for any given catheter position. Radiofrequency ablation was performed in vitro on strips of left ventricular porcine myocardium during two different levels of convective cooling (0 or 0.1 m/s), two different contact pressures (10 or 30 g) and parallel or perpendicular electrode-tissue orientation using 7F 4 mm tip catheters. Prior to ablation the impedance rise (DeltaIMP) caused by the obtained contact and the temperature rise with a 0.6 W 5 s test pulse (DeltaT) were measured. Subsequently, during unchanged conditions, radiofrequency ablation was performed as either temperature-controlled, power-controlled or irrigated tip ablation and lesion size was determined. DeltaIMP increased significantly (P < 0.05) by improved contact, whereas it was not affected by convective cooling. DeltaT was significantly increased by increasing contact pressure (P < 0.05) and significantly decreased by increased cooling (P < 0.001). DeltaT was not systematically affected by electrode orientation. The product of DeltaT and DeltaIMP showed a significant correlation between the obtained lesion size and power output for temperature-controlled and between lesion size and tip temperature for power-controlled ablation (P < 0.001). Pre-ablation measurement of DeltaIMP and DeltaT can indicate the lesion size resulting after ablation in temperature-controlled, power-controlled and irrigated ablation in vitro, since DeltaT reflects cavitary cooling and to a smaller extent electrode-tissue contact, and DeltaIMP reflects only electrode-tissue contact.Keywords
This publication has 30 references indexed in Scilit:
- Can Lesion Size During Radiofrequency Ablation Be Predicted By the Temperature Rise to a Low Power Test Pulse in Vitro?Pacing and Clinical Electrophysiology, 2003
- Tissue Temperature‐Controlled Radiofrequency AblationPacing and Clinical Electrophysiology, 2003
- Using electrical impedance to predict catheter-endocardial contact during RF cardiac ablationIEEE Transactions on Biomedical Engineering, 2002
- Radiofrequency Catheter Ablation Using Cooled Electrodes: Impact of Irrigation Flow Rate and Catheter Contact Pressure on Lesion DimensionsPacing and Clinical Electrophysiology, 2002
- The Effect of Ablation Electrode Length and Catheter Tip to Endocardial Orientation on Radiofrequency Lesion Size in the Canine Right AtriumPacing and Clinical Electrophysiology, 2002
- Electrode Impedance: An Indicator of Electrode-Tissue Contact and Lesion Dimensions During Linear AblationJournal of Interventional Cardiac Electrophysiology, 2000
- Temperature-controlled Radiofrequency Ablation of Cardiac Tissue: An In Vitro Study of the Impact of Electrode Orientation, Electrode Tissue Contact Pressure and External Convective CoolingJournal of Interventional Cardiac Electrophysiology, 1999
- Temperature-controlled radiofrequency catheter ablation of manifest accessory pathwaysEuropean Heart Journal, 1996
- Temperature-guided radiofrequency cathether ablation of slow pathway in atrioventricular nodal reentrant tachycardiaAmerican Heart Journal, 1995
- Radiofrequency coagulation of ventricular myocardium: Improved prediction of lesion size by monitoring catheter tip temperatureEuropean Heart Journal, 1989