Design of passive power filters for a three-phase semi-controlled rectifier with typical loads
Authors:
- 1 June 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21562318,p. 590-595
Abstract
This paper presents the design and simulation of AC and DC passive power filters for a three-phase thyristor-based rectifier. On the source side, the purpose is to achieve harmonic current suppression and reactive power compensation and on the load side, to eliminate the DC voltage ripple. After a brief review of most common filtering methods, the paper emphasizes on the necessity of passive techniques for high power applications. The AC filter consists of RLC branches tuned to harmonic frequencies, while the DC filter inserted at the rectifier output includes a series inductor and shunt connected resistor and capacitor. Matlab/Simulink is the software used for building and simulating the filter models, in the two cases of DC inductive and capacitive loads. The results obtained before and after filtering demonstrate its efficiency in improving the waveforms quality on both AC and DC sides, and therefore in the optimization of power consumption.Keywords
This publication has 5 references indexed in Scilit:
- A study on the impact of a massive integration of compact fluorescent lamps on power quality in distribution power systems2012
- Switch-mode power converters for harmonics mitigation in power systems Technology progress2012
- Harmonic sources and filtering approaches-series/parallel, active/passive, and their combined power filters2003
- A new hybrid filter to dampen resonances and compensate harmonic currents in industrial power systems with power factor correction equipmentIEEE Transactions on Power Electronics, 2001
- Trends in active power line conditionersIEEE Transactions on Power Electronics, 1994