Fast current limitation by conducting polymer composites
Authors:
- 15 May 1997
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 81 (10) , 6786-6794
Abstract
The transition of materials from low resistivity to comparatively high resistivity can be utilized for current limitation, enabling permanent fuses that do not have to be replaced after an overload or short-circuit operation. An interesting class of materials for this purpose are particulate filled polymer composites with a strong positive temperature coefficient (PTC) of resistivity. If an applied current becomes too high, the PTC element is heated to its critical temperature and trips from the conducting into the insulating state. The dynamic heating of the composite upon current flow is described by a one-dimensional model. It is predicted that the heating of a composite depends on the size of the filler particles. Smaller filler particles should allow a faster heating and, hence, a better limitation of the current. Experimental verification is performed using composite of particles in a polyethylene matrix. Commercial powders with different particle-size distributions between 1 and 200 μm were used. The specific resistivity of the composites is small, in the range of 0.01–0.02 Ω cm. Around the melting temperature of the polymer, the resistivity increases within only 20 °C by seven orders of magnitude. In order to verify the expected dependence of the switching dynamic on the filler particle size, the tested elements had comparable electrical characteristics. Samples were prepared having, to a certain degree, the same specific resistivity, cross section, and total resistance. Free parameters were the length, and for some samples, the filler content. Short-circuit experiments show that for decreasing particle size the time until the material trips into the high-resistive state becomes shorter. The best current limitation occurs for composites containing particles in the range of 1–45 μm. Current limitation starts already after 150 μs, and a current density of up to can be switched off within a further 200 μs. The experiments are in excellent agreement with the predictions from theory. Due to the low resistance in the cold state and the very fast limitation of electrical currents, PTC elements based on conducting polymers can be highly attractive for power applications.
Keywords
This publication has 11 references indexed in Scilit:
- Polymer composite thermistors for temperature and current sensorsJournal of Applied Physics, 1996
- New low-voltage varistor compositesJournal of Materials Science, 1996
- Resistance-expansion-temperature behavior of a disordered conductor–insulator compositeApplied Physics Letters, 1996
- Random media with temperature controlled connectivityJournal de Physique I, 1992
- Metal oxide-polymer thermistorsJournal of Materials Science, 1989
- Piezoresistivity of heterogeneous solidsJournal of Applied Physics, 1987
- Resistivity of a composite conducting polymer as a function of temperature, pressure, and environment: Applications as a pressure and gas concentration transducerJournal of Applied Physics, 1986
- PolySwitch PTC Devices-A New Low-Resistance Conductive Polymer-Based PTC Device for Overcurrent ProtectionIEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1981
- Stability of polymer composites as positive‐temperature‐coefficient resistorsPolymer Engineering & Science, 1974
- A new class of switching materialsJournal of Applied Physics, 1973