Finite Difference Heat Exchanger Model: Flow Maldistribution with Thermal Coupling
- 6 May 2020
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 42 (11) , 889-903
Abstract
Channels not receiving the same amount of flow (flow maldistribution) is an important effectiveness loss for high effectiveness heat exchangers. This paper develops a finite difference model of a counter flow heat exchanger. It reproduced the simple NTU result for two channels exactly. For more than two channels, there is an edge effect, and the model agreed within 0.1% of the literature. Perfect agreement was achieved for a simple flow maldistribution case. For independent pairs of hot and cold channels, as flow rate is reduced, the effectiveness asymptotically approaches the irregularity parameter (a measure of channel flow maldistribution). With thermal coupling between pairs of channels (measured by an equivalent Peclet number), effectiveness continues to increase with decreasing flow rate. These results hold for uncorrelated flow maldistribution on both sides or no flow maldistribution on one side. However, when flow maldistribution is positively correlated, effectiveness is higher; and, when it is negatively correlated, effectiveness is lower. A number of resulting graphs illustrate the effectiveness for each channel with different flow rate and correlation. While one exemplary application is a polymer expanded microchannel heat exchanger, the model could be used for other heat exchangers.Keywords
This publication has 14 references indexed in Scilit:
- Expanded Microchannel Heat Exchanger: Nondestructive EvaluationHeat Transfer Engineering, 2018
- Expanded microchannel heat exchanger: design, fabrication, and preliminary experimental testProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2012
- Compensating for End Effects in Plate-and-Frame Heat ExchangersHeat Transfer Engineering, 2005
- Study of flow distribution and its improvement on the header of plate-fin heat exchangerCryogenics, 2004
- Review of polymer compact heat exchangers, with special emphasis on a polymer film unitApplied Thermal Engineering, 2004
- Temperatures and the condensate heat resistance in dropwise condensation of multicomponent mixtures with inert gasesInternational Journal of Heat and Mass Transfer, 2002
- Investigation of Flow Maldistribution in a Concentric-Tube, Counterflow, Laminar Heat ExchangerHeat Transfer Engineering, 1998
- Experimental Study of Particulate Fouling in an Industrial Plate Heat ExchangerJournal of Enhanced Heat Transfer, 1995
- Thermal Effectiveness of Heat Exchangers: Effect of Manufacturing Inaccuracies and Deformation of Tube BundlesHeat Transfer Engineering, 1985
- Effects of Nonuniform Passages on Deepfold Heat Exchanger PerformanceJournal of Engineering for Power, 1977