Prediction of Radiated Emissions From Cables Over a Metal Plane Using a SPICE Model
Authors:
Open Access
- 11 November 2014
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 57 (1) , 61-68
Abstract
A method for creating a simple SPICE model is proposed such that the SPICE model allows prediction of radiated emissions in component level tests, such as those specified by CISPR 25 and MIL-STD 461. The model predicts measured emissions when the antenna is in the vertical direction, where emissions are typically worst for such geometry. It is shown that the radiation from the ground connections between the cables and return plane dominates over the radiation from the horizontal cables. The currents in these ground connections are predicted by treating the cables above the return plane as transmission lines and by treating the ground connections as infinitesimal radiating dipoles. The electric fields generated by these infinitesimal dipoles are summed at the antenna, where the antenna factor is then used to predict the received voltage at the antenna. Test results show that this SPICE model is able to predict peak emissions within a few dB over a range from 60 MHz up to 1 GHz for a variety of circuit configurations. This model should help circuit designers to better evaluate the design of their components early in the design process and help them to better understand the mechanisms behind emissions problems.Keywords
Funding Information
- National Science Foundation (IIP-1440110)
This publication has 9 references indexed in Scilit:
- Transfer Function Method for Predicting the Emissions in a CISPR-25 Test-SetupIEEE Transactions on Electromagnetic Compatibility, 2014
- Estimating the radiated emissions from cables attached to a switching power supply in a MIL-STD 461 test2013
- Substituting EMC emission measurement by field and cable scan method using measured transfer functionAdvances in Radio Science, 2013
- Pre-compliance test method for radiated emissions of automotive components using scattering parameter transfer functions2012
- Simulation of automotive EMC emission test procedures based on cable bundle measurements2012
- A fast radiated emission model for arbitrary cable harness configurations based on measurements and simulations2008
- A model to predict radiated emissions from electronic circuits2002
- Investigation of fundamental EMI source mechanisms driving common-mode radiation from printed circuit boards with attached cablesIEEE Transactions on Electromagnetic Compatibility, 1996
- Exact inductance equations for rectangular conductors with applications to more complicated geometriesJournal of Research of the National Bureau of Standards, Section C: Engineering and Instrumentation, 1965