All Optical Fiber Sensor Based on Asymmetric Staggered Taper and Optical Fiber Bitaper Structure
- 26 June 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 35 (18) , 1002-1005
Abstract
A composite interferometric all-fiber sensor based on an asymmetric misaligned tapered multimode (ASTM) fiber configuration has been designed and investigated. This optical fiber sensor combines the asymmetric staggered taper (AST) structure, single-mode multimode single-mode (SMS) optical fiber and optical fiber bitaper (OFB) structure during preparation. The ASTM-OFB allows for efficient measuring of strains and temperature changes compared to conventional SMS fiber optic architecture. The experimental measurement results show that this new ASTM-OFB fiber optic sensor has two obvious resonance peaks near 1500 nm and 1580 nm, and its strain sensitivity is -37.85 pm/με and -71.92 pm/με respectively, which is about 42 times higher than that of the conventional SMS sensor; the temperature sensitivities in the two resonance peaks are 25.23 pm/°C and 26.47 pm/°C separately. The ASTM-OFB fiber optic sensors measure strain and temperature changes simultaneously with a temperature-strain crosstalk sensitivity of only 0.36 με/°C; its ASTM and OFB structures are prepared by common optical fiber fusion splicing mechanism, with a simple structure, controllable processing parameters and cost-effective.Keywords
Funding Information
- Graduate education innovation program of Guilin University of Electronic technology (2022YCXS232)
- Guangxi Key Laboratory of Wireless Broadband Communication and Signal Processing Director’s Fund Project (GXKL06190106)
This publication has 14 references indexed in Scilit:
- Dual Mach–Zehnder Interferometer Based on Side-Hole Fiber for High-Sensitivity Refractive Index SensingIEEE Photonics Journal, 2019
- Refractometer With Etched Chirped Fiber Bragg Grating Fabry–Perot Interferometer in Multicore FiberIEEE Photonics Technology Letters, 2019
- Multiwavelength Thulium-Doped Fiber Laser Using a Micro Fiber-Optic Fabry–Perot InterferometerIEEE Photonics Journal, 2018
- A Novel Strain Sensor with Large Measurement Range Based on All Fiber Mach-Zehnder InterferometerSensors, 2018
- Temperature and strain sensor based on a few-mode photonic crystal fiber2017
- Strain sensor based on gourd-shaped single-mode-multimode-single-mode hybrid optical fibre structureOptics Express, 2017
- Refractive Index Modulation by Crystallization in Sapphire-Derived FiberIEEE Photonics Technology Letters, 2017
- Hybrid structured fiber-optic Fabry–Perot interferometer for simultaneous measurement of strain and temperatureOptics Letters, 2014
- M–Z Interferometer Constructed by Two S-Bend Fibers for Displacement and Force MeasurementsIEEE Photonics Technology Letters, 2014
- Low-cost high-sensitivity strain and temperature sensing using graded-index multimode fibersApplied Optics, 2007