Microstructure and Mechanical Properties of Wire + Arc Additively Manufactured Mild Steel by Welding with Trailing Hammer Peening
Authors:
- 30 July 2021
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 92 (11)
Abstract
Aiming at solving the problem of coarse grains and poor mechanical properties in weld by Wire Arc Additive Manufacture (WAAM), the welding with trailing hammer peening (WTHP) process is used. The stress state of weld after being processed by WTHP and the temperature distribution at different time are obtained by finite element simulation (FEM). The effects of different peening parameters on microstructure and mechanical properties of the weld are studied by using the light microscopy and Electron Back Scatter Diffraction (EBSD) for microcharacterization. The results show that the hardness of the near‐surface layer of weld is improved by 21.6% using WTHP. Ultimately, the yield strength of weld layer increases from 447 to 493.5 MPa, tensile strength from 560.8 to 661.9 MPa, while the ductility decreases from 32.9% to 21.1%. Three aspects of strengthening mechanisms for the near‐surface layer of the weld by WTHP are as follows: first, multiple high‐speed and high‐energy peening refines the grains of the near‐surface of the weld; second, the plastic deformation produced by hammer peening results in high‐density dislocation and deformation strengthening; and finally, the stress state of the weld is changed from the residual tensile stress to the residual compressive stress under the plastic deformation.Keywords
This publication has 31 references indexed in Scilit:
- Arc characteristics in double-pulsed VP-GTAW for aluminum alloyJournal of Materials Processing Technology, 2017
- Microstructural evolution and mechanical property of Ti-6Al-4V wall deposited by continuous plasma arc additive manufacturing without post heat treatmentJournal of the Mechanical Behavior of Biomedical Materials, 2017
- Fracture toughness and fatigue crack growth rate properties in wire + arc additive manufactured Ti‐6Al‐4VFatigue & Fracture of Engineering Materials & Structures, 2016
- The effectiveness of combining rolling deformation with Wire–Arc Additive Manufacture on β-grain refinement and texture modification in Ti–6Al–4VMaterials Characterization, 2016
- The effect of inter-layer cold working and post-deposition heat treatment on porosity in additively manufactured aluminum alloysJournal of Materials Processing Technology, 2016
- Surface modification by machine hammer peening and burnishingCIRP Annals, 2016
- Electromagneto-fluid Coupling Simulation of Arc Rapid Prototyping Process with External High-frequency Magnetic FieldJournal of Mechanical Engineering, 2016
- The strengthening effect of inter-layer cold working and post-deposition heat treatment on the additively manufactured Al–6.3Cu alloyMaterials Science and Engineering: A, 2016
- Microstructure and residual stress improvement in wire and arc additively manufactured parts through high-pressure rollingJournal of Materials Processing Technology, 2013
- Hybrid direct manufacturing method of metallic parts using deposition and micro continuous rollingRapid Prototyping Journal, 2013