Monitoring System Design for Lateral Vehicle Motion
Authors:
- 3 March 2011
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 60 (4) , 1394-1403
Abstract
Monitoring of lateral vehicle motion is very useful in many active safety applications such as yaw stability control and rollover prevention. Lateral velocity and sideslip angle are regarded as the most important motion variables. However, it is not feasible during vehicle operation to directly measure them due to the high cost of sensors, limitations to sensor technology, etc. Therefore, the monitoring of lateral vehicle motion can be realized by using either accurate monitoring models or improved estimation algorithms. In this paper, monitoring models are obtained such that they utilize not only the vehicle dynamics but the cornering stiffness and the roll motion as well. Based on these monitoring models, three monitoring systems are constructed to estimate the vehicle velocity and the sideslip angle based on the sliding mode observer, the extended Kalman filter (EKF) including Dugoff's tire model, and the scaled Kalman filter with model error compensator (SKFMEC) methods, respectively. The estimation performance of the monitoring systems is verified in field tests, and the experimental results demonstrate the effectiveness of this approach to provide accurate monitoring of lateral vehicle motion.Keywords
This publication has 20 references indexed in Scilit:
- Effect of vehicle model on the estimation of lateral vehicle dynamicsInternational Journal of Automotive Technology, 2010
- Vehicle velocity estimation for real-time dynamic stability controlInternational Journal of Automotive Technology, 2009
- A discrete-time design and analysis of perturbation observer for motion control applicationsIEEE Transactions on Control Systems Technology, 2003
- Monitoring system design for estimating the lateral tyre forceProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2003
- Model error compensation for observer designInternational Journal of Control, 1998
- Nonlinear Tire Force Estimation and Road Friction Identification: Simulation and Experiments ,Automatica, 1997
- Convergence analysis of the extended Kalman filter used as an observer for nonlinear deterministic discrete-time systemsIEEE Transactions on Automatic Control, 1997
- Well-Conditioned Observer Design for Observer-Based Monitoring SystemsJournal of Dynamic Systems, Measurement, and Control, 1995
- Design of observers for linear systems with unknown inputsIEEE Transactions on Automatic Control, 1992
- Combined observer-controller synthesis for uncertain dynamical systems with applicationsIEEE Transactions on Systems, Man, and Cybernetics, 1988