An Improved Shear Stress Monitoring Method in Numerical Direct Shear Tests by Particle Flow Code
Authors:
- 8 January 2019
- journal article
- research article
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 48 (6) , 4136-4152
Abstract
During a direct shear test in particle flow code (PFC; Itasca Consulting Group, Minneapolis, MN) simulation, the initial force is often neglected by the existing methods of monitoring shear stress, which results in a difference between the monitoring data and simulation result. An improved monitoring method, which involves monitoring the resultant force on the left and right walls (specimen boundary) as the shear force, is proposed to monitor the shear stress in this study. The effectiveness of the proposed method is first investigated by comparing the monitoring results with the peak shear strength of sawtooth triangular joints with base angles of 0°, 15°, and 30° and joints with Barton’s standard joint roughness profiles (joint roughness coefficient (JRC) = 5.8, 10.8, and 14.5) as predicted by well-known classical shear models under different normal stress conditions. Additionally, the capabilities of the proposed monitoring method were tested by comparing it with the peak shear strength obtained from laboratory direct shear tests on a real rock joint (JRC = 1.0) under different normal stress levels. Good agreement was found between the results of the numerical models that used the proposed monitoring method and well-known classical shear models as well as laboratory direct shear tests. The proposed method has a highly accurate capacity for determining the shear stress in numerical direct shear tests by PFC. This method has advantages for assessing joints with low roughness coefficients under low normal stress conditions. The results reveal that the proposed method reasonably reflects the shear characteristics of rock joints in numerical direct shear tests. The proposed method also contributes to the calibration of microparameters for a smooth joint model to more accurately represent the rock joint.Keywords
This publication has 25 references indexed in Scilit:
- Numerical direct shear tests to model the shear behaviour of rock jointsComputers and Geotechnics, 2013
- REV and its properties on fracture system and mechanical properties, and an orthotropic constitutive model for a jointed rock mass in a dam site in ChinaComputers and Geotechnics, 2012
- The synthetic rock mass approach for jointed rock mass modellingInternational Journal of Rock Mechanics and Mining Sciences, 2011
- Estimating geometrical and mechanical REV based on synthetic rock mass models at Brunswick MineInternational Journal of Rock Mechanics and Mining Sciences, 2010
- Numerical simulation of a direct shear test on a rock joint using a bonded-particle modelInternational Journal of Rock Mechanics and Mining Sciences, 2009
- Stability analysis of vertical excavations in hard rock by integrating a fracture system into a PFC modelTunnelling and Underground Space Technology, 2009
- FLAC/PFC coupled numerical simulation of AE in large-scale underground excavationsInternational Journal of Rock Mechanics and Mining Sciences, 2007
- Efficient numerical modelling of faulted rock using the boundary element methodInternational Journal of Rock Mechanics and Mining Sciences, 1994
- Boundary integral analysis of piecewise homogeneous media with structural discontinuitiesInternational Journal of Rock Mechanics and Mining Sciences, 1985
- A discrete numerical model for granular assembliesGéotechnique, 1979