Heat Transfer in an Air-Cooled Rotor–Stator System
Authors:
- 1 July 1996
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 118 (3) , 444-451
Abstract
This paper describes a combined experimental and computational study of the heat transfer from an electrically heated disk rotating close to an unheated stator. A radial outflow of cooling air was used to remove heat from the disk, and local Nusselt numbers were measured, using fluxmeters at seven radial locations, for nondimensional flow rates up to Cw = 9680 and rotational Reynolds numbers up to Reφ = 1.2 × 106 Computations were carried out using an elliptic solver with a low-Reynolds-number k–ε turbulence model, and the agreement between the measured and computed velocities and Nusselt numbers was mainly good.Keywords
This publication has 13 references indexed in Scilit:
- Flow Between Contrarotating DisksJournal of Turbomachinery, 1995
- Local Heat Transfer in Turbine Disk Cavities: Part II—Rotor Cooling With Radial Location Injection of CoolantJournal of Turbomachinery, 1992
- Local Heat Transfer in Turbine Disk Cavities: Part I—Rotor and Stator Cooling With Hub Injection of CoolantJournal of Turbomachinery, 1992
- Computation of the flow and heat transfer due to a rotating discInternational Journal of Heat and Fluid Flow, 1991
- Heat Transfer From a Rotating Disc1990
- Numerical Prediction of Turbulent Flow in Rotating CavitiesJournal of Turbomachinery, 1988
- The Effect of Disk Geometry on Heat Transfer in a Rotating Cavity With a Radial Outflow of FluidJournal of Engineering for Gas Turbines and Power, 1988
- Transfer of Heat in Rotating Systems1976
- A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flowsInternational Journal of Heat and Mass Transfer, 1972
- NOTE ON A CLASS OF SOLUTIONS OF THE NAVIER-STOKES EQUATIONS REPRESENTING STEADY ROTATIONALLY-SYMMETRIC FLOWQuarterly Journal of Mechanics and Applied Mathematics, 1951