Densification Mechanism of SnO2 Ceramics Doped with 5.0 mol% MnO2
Authors:
- 1 October 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 351, 88-92
Abstract
Dense SnO2 based ceramics are widely used. In this paper, 95SnO2-5MnO2 ceramics were prepared by pressureless sintering in air at different temperatures. Phase compositions and microstructures are examined by XRD, SEM and EDX, respectively. The SEM results show that different morphologies exist at the SnO2 grain boundary of ceramic, which compose of manganese oxidation, testified by EDX. The different manganese oxides phases, found by XRD, are the source of oxygen concentration at the grain boundary during heating and oxygen dissipation when cooling. However, solid solutions of Mn, Sn and O are not observed. The density of 95SnO2-5MnO2 ceramics decreases with increasing the sintering temperature, due to the evaporation of SnO and decreasing concentration of oxygen at grain boundary in the cooling process. Densification of the ceramic is promoted with inhibiting the decomposition of SnO2 by increasing oxygen concentration in the heating process, but it is limited by the dissipation of oxygen at the grain boundary in the cooling process.Keywords
This publication has 9 references indexed in Scilit:
- Sintering of tin oxide using zinc oxide as a densification aidJournal of Materials Science, 2004
- Influence of the additives and processing conditions on the characteristics of dense SnO2-based ceramicsJournal of Materials Science, 2003
- Densification and coarsening of SnO2-based materials containing manganese oxideJournal of the European Ceramic Society, 1998
- Densification of 0·99SnO20·01CuO mixture: Evidence for liquid phase sinteringJournal of the European Ceramic Society, 1992
- The Effect of Additives on the Sintering of Tin OxideSolid State Phenomena, 1992
- Contribution to the study of SnO2-based ceramicsJournal of Materials Science, 1991
- Densitication of nonadditive SnO2 by hot isostatic pressingCeramics International, 1984
- Enhanced Sintering of Tin Dioxide with Additives under Isothermal ConditionTransactions of the Indian Ceramic Society, 1983
- Physical Properties of SnO2 Materials: I . Preparation and Defect StructureJournal of the Electrochemical Society, 1976