Possible explanations for different surface quality in laser cutting with 1 and 10 μm beams
Authors:
Open Access
- 30 December 2011
- journal article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 24 (1) , 012006
Abstract
In laser cutting of thick steel sheets, quality difference is observed between cut surfaces obtained with 1 and 10 μm laser beams. This paper investigates physical mechanisms for this interesting and important problem of the wavelength dependence. First, striation generation process is described, based on a 3D structure of melt flow on a kerf front, which was revealed for the first time by our recent experimental observations. Two fundamental processes are suggested to explain the difference in the cut surface quality: destabilization of the melt flow in the central part of the kerf front and downward displacement of discrete melt accumulations along the side parts of the front. Then each of the processes is analyzed using a simplified analytical model. The results show that in both processes, different angular dependence of the absorptivity of the laser beam can result in the quality difference. Finally, the authors propose the use of radial polarization to improve the quality with the 1 μm wavelength.Keywords
This publication has 20 references indexed in Scilit:
- Laser power requirement for cutting thick-section steel and effects of processing parameters on mild steel cut qualityProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2011
- Experimental investigation of hydrodynamics of melt layer during laser cutting of steelJournal of Physics D: Applied Physics, 2011
- Laser deep penetration welding simulation based on a wavelength dependent absorption modelPhysics Procedia, 2010
- Theoretical aspects of fibre laser cuttingJournal of Physics D: Applied Physics, 2009
- Visualization of events inside kerfs during laser cutting of fusible metalJournal of Laser Applications, 2009
- Numerical analysis of the effect of the TEM00radiation mode polarisation on the cut shape in laser cutting of thick metal sheetsQuantum Electronics, 2005
- Corners, Cusps, and Pearls in Running DropsPhysical Review Letters, 2001
- Influence of beam polarization on laser cutting efficiencyJournal of Physics D: Applied Physics, 1999
- The simulation of front keyhole wall dynamics during laser weldingJournal of Physics D: Applied Physics, 1997
- Energy Coupling Efficiency in Laser Surface Treatment.ISIJ International, 1993