Study of patient-orthosis interaction forces in rehabilitation therapies
- 1 June 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21551774,p. 1098-1103
Abstract
The design of mechanical joints that kinematically behave as their biological counterparts is a challenge that if not addressed properly can cause inadequate forces transmission between robot and patient. This paper studies the interaction forces in rehabilitation therapies of the elbow joint. To measure the effect of orthosis-patient misalignments, a force sensor with a novel distributed architecture has been designed and used for this study. A test-bed based on an industrial robot acting as a virtual exoskeleton that emulates the action of a therapist has been developed and the interaction forces analyzed.Keywords
This publication has 21 references indexed in Scilit:
- ABLE, an innovative transparent exoskeleton for the upper-limb2008
- RUPERT: An exoskeleton robot for assisting rehabilitation of arm functions2008
- Development of a hinge compatible with the kinematics of the knee jointProsthetics and Orthotics International, 2007
- MEDARM: a rehabilitation robot with 5DOF at the shoulder complex2007
- Upper-Limb Powered Exoskeleton DesignIEEE/ASME Transactions on Mechatronics, 2007
- ARMin - Exoskeleton for Arm Therapy in Stroke Patients2007
- Passive exoskeletons for assisting limb movementJournal of Rehabilitation Research and Development, 2006
- Design of an arm exoskeleton with scapula motion for shoulder rehabilitation2005
- Development and Control of a ‘Soft-Actuated’ Exoskeleton for Use in Physiotherapy and TrainingAutonomous Robots, 2003
- Zur Biomechanik des Tibiofemoralgelenks und deren Umsetzung bei KnieorthesenDer Orthopäde, 2002