A novel method of cold expansion which creates near‐uniform compressive tangential residual stress around a fastener hole
- 1 April 2004
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 27 (5) , 343-351
Abstract
A recognized way of improving the fatigue resistance of a fastener hole is to introduce compressive tangential residual stress around it. This can be achieved by using a cold expansion method in which an oversized pin or ball is forced through the hole to produce a local plastic region surrounded by an elastic one. Once the pin or ball is removed allowing the elastic region to spring back it results in compressive tangential residual stress around the hole. In practise, however, it is found that such a cold expansion method creates a non‐uniform residual stress distribution through the plate thickness and even tensile residual stress can be created at the entrance and exit faces. In this paper a new method of cold expansion is proposed. It uses a tapered pin with a mating tapered split sleeve and creates an almost uniform compressive residual stress around the hole as shown by FE method. Also, fatigue tests were carried out to verify that the method does significantly improve fatigue life. Finally the tangential residual stress distribution and fatigue life improvement of this new method were compared with those of a well‐established cold expansion method and it was shown that the new method is more efficient in improving fatigue life.Keywords
This publication has 14 references indexed in Scilit:
- The effect of cold expansion on improving the fatigue life of fastener holesEngineering Failure Analysis, 2003
- Effect of expansion technique and plate thickness on near-hole residual stresses and fatigue life of cold expanded holesJournal of Materials Science, 1999
- Three-dimensional finite element analysis of cold expansion of adjacent holesInternational Journal of Mechanical Sciences, 1998
- A Finite Element Simulation of the Cold Workingprocess for Fastener HolesThe Journal of Strain Analysis for Engineering Design, 1997
- Prediction of notch fatigue limits in a compressive residual stress fieldEngineering Fracture Mechanics, 1996
- Fatigue properties of cold worked holesJournal of Materials Processing Technology, 1995
- Three-dimensional stress distribution around cold expanded holes in aluminium alloysEngineering Fracture Mechanics, 1994
- Effect of residual stress on fatigue behaviour of notchesInternational Journal of Fatigue, 1994
- Fatigue properties of holes with residual stressesEngineering Fracture Mechanics, 1993
- An experimental study of fatigue crack initiation and growth from coldworked holesEngineering Fracture Mechanics, 1979