Tunable Diode Laser Absorption Spectroscopy Diagnostics of Potassium, Carbon Monoxide, and Soot in Oxygen-Enriched Biomass Combustion Close to Stoichiometry
- 2 October 2019
- journal article
- research article
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 33 (11) , 11795-11803
Abstract
Combustion facilities run on pulverized biomass often exhibit fluctuations in fuel feeding and thus equivalence ratio, and would benefit from fast process control based on optical lambda sensors installed in the reactor core. The conversion of softwood powder is investigated in an atmospheric entrained-flow reactor (EFR) operated close to stoichiometry using two different burners (Swirl and Jet) and three oxygen concentrations (21%, 30% and 40%). Tunable diode laser absorption spectroscopy (TDLAS) is used to conduct time-resolved (0.1-1 s) in situ measurements of gas temperature, carbon monoxide (CO), water vapor (H2O), atomic potassium, K(g), and soot volume fraction in the lower part of the reactor core and in the exhaust of the EFR. At both locations, the measurement parameters show significant, correlating fluctuations. The local equivalence ratio is derived from a comparison of measured CO and H2O concentrations (for fuel-rich and fuel-lean conditions, respectively) to thermodynamic equilibrium calculations (TEC), and found to in a wide range (0.8 to 1.3). Soot production decreases with increasing local equivalence ratio and oxygen-enrichment, and is lower for the Swirl compared to the Jet burner. The measured K(g) concentrations follow the general behavior predicted by TEC around stoichiometry. In the relevant temperature range (1100-1700 K), K(g) is 2-4 orders of magnitude higher under fuel-rich than under fuel-lean conditions with a sharp transition at stoichiometry. While K(g) concentrations are lower than TEC in the reactor core and under fuel-rich conditions, excellent agreement is found at the exhaust after complete fuel conversion. Precise, wide dynamic range detection of K(g) using TDLAS enables discrimination between fuel-rich and fuel-lean conditions, and has the potential for lambda sensing close to the hot reaction zone of combustion plants.Keywords
Funding Information
- Energimyndigheten
- Kempestiftelserna (JCK-1316)
- Swedish strategic research program Bio4Energy
- Swedish Gasification Centre
This publication has 36 references indexed in Scilit:
- Combustion measurements of type-1 pulverized coal flames operating under oxy-fired conditionsFuel Processing Technology, 2018
- Optical techniques for characterizing the biomass particle flow fluctuations in lab- and pilot-scale thermochemical systemsPowder Technology, 2017
- Solid-state gas sensors for high temperature applications – a reviewJournal of Materials Chemistry A, 2014
- Support vector machine based online coal identification through advanced flame monitoringFuel, 2014
- Pulverised wood combustion in a vertical furnace: Experimental and computational analysesApplied Energy, 2013
- Ash transformations in pulverised fuel co-combustion of straw and woody biomassFuel Processing Technology, 2013
- Biomass feeding for thermochemical reactorsProgress in Energy and Combustion Science, 2012
- Resistive Oxygen Gas Sensors for Harsh EnvironmentsSensors, 2011
- Combustion of wood hydrolysis residue in a 150kW powder burnerFuel, 2004
- Wood powder feeding, difficulties and solutionsBiomass and Bioenergy, 1999