Prediction of Broadband Noise in an Automotive Centrifugal Compressor with Three-Dimensional Computational Fluid Dynamics Detached Eddy Simulations
Authors:
- 5 June 2019
- journal article
- research article
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 01 (4) , 1714-1720
Abstract
Centrifugal compressors for automotive turbochargers must operate over wide speed and flow ranges to provide the required air pressure and mass flow rate to the intake manifold of the internal combustion engines. At a fixed rotational speed, the flow field near the inducer of the impeller becomes increasingly unstable with decreasing flow rate, as the incidence angle grows between the air flow approaching the impeller, relative to the tangent of the main impeller blades at the leading edge. Flow field measurements conducted earlier have revealed that once the incidence angle exceeds a critical value (nearly independent of rotational speed) of approximately 15°, reversed flow near the periphery (blade tips) starts penetrating upstream of the impeller, with a high tangential velocity in the direction of impeller rotation. As the incidence angle is increased towards this critical value, whoosh noise elevates, where it remains high for a significant portion of the mid-flow operating range, before decreasing at further elevated incidence angles. To understand this phenomenon further, a detailed, three-dimensional (3D) computational fluid dynamics (CFD) model of the experimental setup was constructed, and simulations were completed at four flow rates along a constant rotational speed. Predictions from this 3D CFD model agree reasonably well with experiments, including the steady-state performance, time-averaged flow field, and noise as captured from the pressure transducer installed in the compressor inlet duct. Near the peak whoosh noise of the studied speed, the impeller flow field was closely examined. Predictions reveal the highest total sound pressure level in the whoosh frequency range occurs near the inducer plane, within the shear layer between the concentric, bi-directional flow structure, with forward flow closer to the axis and reversed flow around the periphery.Keywords
This publication has 9 references indexed in Scilit:
- Investigation of Cross-Sectional Velocity Field Near the Inducer Plane of a Turbocharger Compressor Using 2D Particle Image Velocimetry2019
- The Effect of Ported Shroud Recirculating Casing Treatment on Turbocharger Centrifugal Compressor AcousticsSAE International Journal of Engines, 2017
- Numerical and experimental analysis of automotive turbocharger compressor aeroacoustics at different operating conditionsInternational Journal of Heat and Fluid Flow, 2016
- Effect of Aerodynamically Induced Pre-Swirl on Centrifugal Compressor Acoustics and PerformanceSAE International Journal of Passenger Cars - Mechanical Systems, 2015
- Noise at the mid to high flow range of a turbocharger compressorNoise Control Engineering Journal, 2014
- Effect of inlet vanes on centrifugal compressor acoustics and performanceNoise Control Engineering Journal, 2014
- Computational Aero-Acoustics Simulation of Compressor Whoosh Noise in Automotive TurbochargersSAE International Journal of Advances and Current Practices in Mobility, 2013
- Investigation of Compressor Whoosh Noise in Automotive TurbochargersSAE International Journal of Passenger Cars - Mechanical Systems, 2009
- Sound generation in centrifugal compressorsJournal of Sound and Vibration, 2008