A complementary dynamic residue amplifier for a 67 dB SNDR 1.36 mW 170 MS/s pipelined SAR ADC
Authors:
- 1 September 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19308833,p. 215-218
Abstract
A complementary dynamic single-stage residue amplifier for a pipelined SAR ADC is presented. It re-uses charge typically wasted during the reset phase, and hence improves efficiency by a factor 2× in this block that often dominates the fundamental noise/power trade-off of the ADC. The residue amplifier achieves 90 μVrms input noise for an energy consumption of 1.5 pJ. It is used in a 2-times interleaved 6b coarse/8b fine pipelined SAR ADC. The 40nm CMOS prototype achieves 11 ENOB at 20 MS/s while consuming 165 μW, leading to an energy per conversion step of 4 fJ. It maintains more than 10.8 ENOB at low input frequencies for a clock frequency up to 180 MS/s.Keywords
This publication has 6 references indexed in Scilit:
- A 70 dB SNDR 200 MS/s 2.3 mW dynamic pipelined SAR ADC in 28nm digital CMOS2014
- 11.4 A 1.5mW 68dB SNDR 80MS/s 2× interleaved SAR-assisted pipelined ADC in 28nm CMOS2014
- A 10-Bit 800-MHz 19-mW CMOS ADCIEEE Journal of Solid-State Circuits, 2014
- Problem of timing mismatch in interleaved ADCs2012
- A 15.5 dB, wide signal swing, dynamic amplifier using a common-mode voltage detection technique2011
- A low-noise self-calibrating dynamic comparator for high-speed ADCs2008