Study on the weldability of stainless steel fabricated by powder metallurgy and metal injection molding for optoelectronic packages
Authors:
- 1 August 2006
- journal article
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 45 (8) , 084002-084002-6
Abstract
To reduce the cost of optoelectronic modules, powder metallurgy (PM) and metal injection molding (MIM) are employed to fabricate metal housings for optoelectronic packages. During the laser welding of PM steel, the rising gas pressure pushes the molten metal out of the welding regions, resulting in weak and unstable joints. Metal parts fabricated by the MIM method provide good weldability, shape complexity, low cost, and long-term reliability. By using the MIM method, defect-free welding joints and postwelding-shifts of less than are achieved, and the optoelectronic packages are reliable. Employment of MIM not only gives optoelectronic module designers more design flexibility due to the advantage of shape complexity, but also makes low-cost triple-directional optoelectronic modules realizable.
Keywords
This publication has 10 references indexed in Scilit:
- A novel fiber alignment shift measurement and correction technique in laser-welded laser module packagingJournal of Lightwave Technology, 2005
- An Optimum Approach for Reduction of Fiber Alignment Shift of Fiber-Solder-Ferrule Joints in Laser Module PackagingJournal of Lightwave Technology, 2004
- Trends in laser packaging2002
- Laser welding induced alignment distortion in butterfly laser module packages: effect of welding sequenceIEEE Transactions on Advanced Packaging, 2002
- A 1.3/1.55-/spl mu/m wavelength-division multiplexing optical module using a planar lightwave circuit for full duplex operationJournal of Lightwave Technology, 2000
- Cost-effective optical module for optical access systemIEEE Photonics Technology Letters, 1998
- Effect of Au thickness on laser beam penetration in semiconductor laser packagesIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part B, 1997
- Laser weldability analysis of high-speed optical transmission device packagingIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part B, 1996
- Laser welding for fiber pigtailing with long-term stability and submicron accuracyOptical Engineering, 1995
- Optical components-the new challenge in packagingIEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1990